0
It's usually screwed into the intake manifold towards the front, near the thermostat housing.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the temperature sending unit on a 1977 302?
The temperature sending unit on a 1977 302 engine is on the front. It is located in front of and to the right of the intake manifold.
How do you change the sending unit on a 1986 Chevy Blazer?
Which sending unit? Oil or temperature? Or ?????
Where is the temperature sending unit for a 95 Chevy beretta?
The temperature sending unit for a 1995 Chevy Beretta is on the front of the engine. It is between the front of the engine and the radiator inlet/outlet.
Where is the temperature sending unit in a 1996 Chevy Camaro?
230.3fh
How do you replace sending unit 1994 Chevy 1500 5.7?
We need to know which sending unit you speak of. There are several on that vehicle such as temperature sending unit, oil pressure sending unit and fuel gauge sending unit.
How to you replace sending unit on 1977 Chevy pick up?
There are several sending units in that vehicle, need to know which one.
What year Chevy 350 engine do you have?
where are the temperature sending unit located on a 1990 Chevy engine 5.7
Where is the Temperature sending unit located on a 1988 Chevy 305?
connected to thermostat housing
Why wont the temperature gague work in my 1996 Chevy silverado?
Bad temperature sending unit? Bad gauge?
If the temperature gauge on a 72 Chevy Suburban 350 does not move from cold is there a problem with the thermostat or the sending unit?
I will doubt the connection or the sending unit. Hope this will help.
Where is the cooling sending unit on a 2000 Chevy s10?
Assuming you mean the engine coolant temperature sending unit, we need to know what engine it has, it makes a difference.
How do you put on a single wire water temperature sending unit on a 1994 s10 Chevy?
There are actually two water temperature sending unit on a 1994 S10 Chevy. Please locate the unit close to the thermostat housing, and not the one between spark plugs. The single wire water temperature sending unit should then be attached to the temperature gauge. The two wire unit, the one between spark plugs, would be connected to the engine control module.
