The Hydraulic Control Unit for the 1995 Ford Ranger 4 wheel anti-lock brake system 4WABS is located in the engine compartment on the left front inner fender panel. It consists of: the brake pressure control valve block, pump motor and hydraulic control unit reservoir. The "brains" of the 4WABS in the Ranger is the Brake Control Module, or Electronic Control Unit (ECU). The ECU/Brake Control Module is mounted in front of the right front corner of the battery on the radiator support.
In a 1997 Ford Ranger, the wiper control module is located behind the radio compartment. It sits on the left side of the compartment.
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
somewhere in the cab, probably behind the seats
it is found on the passenger side kick panel also called a 4x4 control module
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
the engine control module (ecm) is located behind the passanger kick pannel. which is located by the floor, passanger side.
Driver side on firewall behind cruise control module
On a 2001 Ford Ranger : In the Power Distribution Box ( which is " live " ) located in the engine compartment , on the drivers side ( the # 54 relay is the relay for the Powertrain Control Module / PCM )
it is not an alarm module it is called a G.E.M. module,and it located behind the radio in the dash.and to replaced it has to be reprogrammed
Check behind the glove compartment. The TCCM (Transfer Case Control Module) is located there on some Ford vehicles like the Exploder and the Ranger.
where is the restraints control module located on an 08 ford escape hybrid
Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC