0
Where is the access cover for the flywheel and drive belt on a 1992 Mazda protege?
Wiki User
∙ 16y ago
at the back of motor in front of transmission at the bottom have to remove 4 , 10mm bolts hope this helps
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the Diagnostic port on a 1992 Mazda Protege?
Near the battery. It will have "DIAGNOSTIC" on the cover.
Where is the horn on a 98 Mazda Protege?
Well I had a 1995 Protege but I think is on the same place. It's beehint the right corner of the front cover. You have to remove the black cover under the car to see it. Mazda hide pretty well.
Where is the dipstick located on a 1991 Mazda protege 323?
IF ITS A 1.8, THEN ITS NEXT TO THE TIMING COVER
Where is the water pump located on a 1998 Mazda Protege?
The water pump is under the timing belt cover. To access the water pump, you must first remove both belts, the water pump pully, and the timing belt cover.
Where is the PCV valve located on a 1998 Mazda Protege 4 cylinder?
On my 1997 Protege a hose runs from the valve cover to the air intake assembly. Where the hose connects to the valve cover is the PCV valve.
Where is the camshaft sensor CPS in a 1.6L 5-speed 2000 Mazda Protege?
on the cover of the timing belt
What is the valve cover torque on a 2000 Mazda Protege 1.8L?
The 2000 Mazda 1.8 liter engine valve cover torque specification is 45 pounds. The valve cover bolts should be torqued in 15 pound intervals.
Where is the PCV valve on a 1999 Mazda Protege?
on 99 models with 1.8 liters on top of engine in center of valve cover
Where is the horn in a 1996 Mazda Protege?
Just behind the right corner of the front bumper. You have to remove the black cover under the car to see it. Mazda hide it pretty well.
How can I find out what each of the fuses are used for 2000 Mazda Protege?
if you look on the back of the cover of the fuse box it should have a diagram with labels for all the fuses
Where is a Mazda protege 2001 fuel injector located?
The fuel injectors are located under the fuel rail, between the intake manifold and the valve cover.
How do you disassemble the rear brake light cover so you can replace the brake light bulb on an '03 Mazda Protege 5?
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
