Where is the air conditioning expansion valve on 1990 Honda civic 1.5?

How do you change the ac expansion valve on a 2001 Honda civic

Inside the evaporator case which is behind the glovebox

Take it to an a/c man. He has the knowledge and tools to do it.

The AC receiver drier on a 1995 Honda Civic is on the high-pressure side of the system. It is between the expansion valve inlet and condenser outlet.

Where is the PVC valve on a 2002 Honda Civic EX?

where is the iac valve on a 99 honda civic lx?

Locate heater control valve in a 2001 Honda civic

VALVE CLEARANCE FOR A 2000 HONDA CIVIC EX 2 DOOR

Pcv valve job on 95 civic

The expansion valve, on your 1998 Honda Accord, is located just before the thermostat housing. You can follow the water hose from the radiator to the expansion valve.

The expansion valve is found inside the evaporator housing. To replace the AC system needs to be flushed legally. Then valve is only held down by a few mounting screws. Once the AC system is bled, loosen the screws and replace the unit.

The 1989 Honda Civic is not equipped with an EGR valve.

The 2005 Nissan air conditioning compressor expansion valve is located on the bottom of the compressor. The expansion valve should be labeled as such.

how do you replace the expansion valve

On a 1985 Honda Civic, the PCV valve is situated on the firewall side of the engine. The valve is connected to the rubber hose.

Idle on a 1985 Honda Civic is adjusted through a idle air control valve. This valve is located near the intake. Adjust the valve by either loosen or tightening it.

b16a valve clearence

PCV valve (A)

The PCV valve of a Honda Civic is usually located on the upper right corner of the intake manifold. The position can vary, but this is typical of any automobile.

The expansion valve is located under the dash. It is within the plasitc housing (box shaped) with the condensor coil. The plastic housing can be removed after taking out the glove box, metal cross bar, and disconnectng the wire harness that runs across the plastic housing.

Should be located next to the evaporator behind the dash on the passenger side. Definately a pain to get at but a necessary replacement if compressor shelled itself out.

under the glove box

The idle speed on a 2001 Honda Civic is adjusted through the idle air control valve. The valve is located behind the intake manifold. Open the cover using a screwdriver and tighten the valve to lower the idle.

intake valve 0. 20mm exhaust valve 0. 25mm

The 1996-2000 Honda Civic came with the 1.6-liter SOHC 4-cylinder 16-valve engine.

could be broken valve collar or you have dropped a valve

The 1983 civic, hatchback with 1.5 engine does not have one.

The 1992-1995 Honda Civic LX Sedan has a 102 horsepower 16 valve engine called the D1587.

1998 Honda civic lx

There isn't one.

There can be many causes for a Honda Civic to stall. Some of them include a bad fuel pump, a bad alternator, a bad distributor, a clogged air filter or idle air valve. Buy a Honda Civic Service manual for more information. http://www.HondaCivicRepairs.com do it myself Honda civic repair

To adjust the idle on a 2005 Honda Civic locate the idle control valve. The IACV and is found near the intake manifold. Open the top of the valve and tighten it to lower the idle or loosen it to raise it.

The expansion valve on a 1997 Honda Accord AC is located in line with the tube that supplies liquid coolant to the air conditioner vapor. It is mounted right beside the tube.

Yes. Otherwise you wouldnt have air conditioning in your vehicle.

im not sure on a 1990 but on my 93 civic ex 1.6 vtec the PVC valve is on the intake right under the fuel rail

By the last fuel injectoron on the intake manifold

intake 7 exaust 9

The torque should be 7ft-lbs.

Idle Air Control Valve.

in the thermostat housing. my 97 has it locked, I can`t open up.

The cost to replace a Honda PCV valve runs between $5 and $20. This depends on the car year make, the store and the part brand.

My 1998 Civic EX engine (CA emissions) vents the upper valve cover into the air intake for combustion. I could not locate a traditional Positive Crankcase Ventilation (PVC) valve on my vehicle.

Expansion valve or orifice tube.

If it has an idler control valve, and most do, I'd go with that.

NO.,Well yes it is computer controlled.

The expansion valve is located in and with the evaporator, inside the evaporator case. This case is a somewhat square, plastic enclosure located directly behind the glove box on this vehicle.

Book time for the evaporator is 2 hours, follow the a.c. lines to the fire wall and under the dash on that side attatched to the evaporator will be your expansion valve.

firing order for Honda civic dx1.5 16 value (Valve) 1, 3, 4, 2.

you have to remove lines under hood located on passenger side after evacuating freon from the system then remove glove box you will see that the box behind there seperates and comes out just the section that the evaperator core is in the expansion valve is inside this box which splits in half after removing the screws open the box you will see exspansion valve where lines from outside hook up

The valves on a 1998 Honda Civic EX can be adjusted using a feeler gauge. First remove the valve cover to access the valves. Using a factory service manual look up the proper valve adjustment gauge. Using a special valve socket to tighten and loosen them to the appropriate feeler gauge settings.