0
passenger side of engine, low, towards firewall seat. i just removed mine, but can't get it out of the engine cavity. may have to remove the tierod, maybe even axle>?
The alternator can be coaxed out from the top by moving a couple of hoses and the wire harness as far towards the driver side as you can. With just the right tilt--it will come out!
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the alternator located on a 1999 Mazda 626 LX-v6?
The 1999 Mazda 626 alternator is located on the right hand side of the engine. The alternator will be near the front of the engine.
How do you remove the alternator on a Mazda 626 1989?
Remove passenger side Rack and pinion arm and slide out Alternator .
Where is the brake fluid reservoir in a 1989 Mazda 626?
The brake fluid reservoir on a 1989 Mazda 626 is on the master cylinder. This is located in the engine compartment on the drivers side.
Where is the thermostat located on a 1999 Mazda 626?
Where is the thermostat located on a 1999 Mazda 626?
Where is the Voltage regulator in a 1996 Mazda 626?
It is built into the alternator...
Where is the cabin filter located on a 2006 Mazda 626?
Where is the cabin filter located on a 2002 Mazda 626?
How do you disconnect drive shafts on a 1989 Mazda 626?
See the Related Links for "mazda 626 forum" to the bottom for the answer.
Spark plug gap for 1989 Mazda 626?
1989 Mazda 626 2.2L FI 4cylThe Spark Plug Gap.044 (In thousandths of an inch)
Where is the starter located on a Mazda 626 4 cylinder?
Where is starter on a 4 cylinder mazda 626?
How do you change alternator belt on a 1998 Mazda 626?
To change the alternator belt on a 1998 Mazda 626 you need to first loosen the bolt that is located in the center of the adjustment pulley. Next, turn the adjustment bolt to the left until the belt is loose and can be removed. Reverse the steps to replace with the new belt.
How do you change thermostat 2002 Mazda 626 V6 2.5L?
Where is the thermostat located on a mazda 626 2002
Where is the alternator for a 1998 Mazda 626?
The positive battery terminal cable will always run to the alternator- just follow it down.
