for 4cylinder engines, the Alt. is located near the bottom of the engine on the passenger side..
for v6, it's located behind the front passenger side headlight.
The fuel pressure regulator is located on the fuel rail of the vehicle.
waste of time
The fuel pressure regulator is located on the fuel rail of the vehicle. It should be on the head closest to the front of the vehicle.
on the alternator on top is a bolt losen that bolt and it will allow you to move alternator causing belt to losin
Under the back seat
its located on the floor behind the consol underneath the dash
its located behind the front bumper by the passenger side headlight
The 1993 Mazda the inertia?æswitch can be found on the firewall in the engine compartment. The inertia switch will be on the passenger side of the firewall.
The idle air control valve is on the the bottom of the throttle body.
I haven't been able to find.
A 1993 Mazda MX-3 does not have an inertia switch. If anything is wrong with what would normally be the inertia switch, the fuel pump may be faulty.
in engine bay fuse board
ckeck for vac. leak at brake booster
What causes my Mazda mx3 to turn off while driving down the road.
What are the head bolt torque specs for a mazda mx3 1600
In order to remove the alternator on a 1.6 liter four cylinder you will have to remove the a/c line going into the car located on the passenger side. Then you will have the room to remove the alternator from the car. There are 2 bolts holding the alternator in 1 on top and the other on the bottom. This is a fairly easy job should take about 15 - 25 minutes to complete.
It is located on the inside of the distributor . Three pin connector .
Mazda has a recall on their seatbelts for some models for this reason. ask a Mazda dealer if your model has the seatbelt recall. I believe the 92 mx3 has a recall for the auto seatbelts, but i am not sure about 93. Look into it though and they might fix it for free!
The neutral safety switch, release switch, or brake switch is bad.
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
Necessity speedometer sensor que va en el panel de instrument cluster vin jm1ec4313p0212457 mazda mx-3, 1.6l , 4 cylinder's, automatic ano 1993
The flasher box in the Mazda MX3 is the plug in that controls the flashers for the turn signals and also the hazard lights. This part is located under the dash on the driver's side, just above the brake pedal area.
In the fuse box under the hood, driver's side