0
Where is the alternator or starter motor on opel astra 1.4 1999?
Wiki User
∙ 14y ago
under the bonnet.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove the starter from a 1999 Audi a6?
How do i remove an Audi A6 Starter motor
Why will 1999 Volkswagen Beetle not start after replacing battery?
You need to replaced the starter or the alternator.
How do you take a starter out of Nissan primera?
how do you take a starter motor off of a 1999 nissan primera auto
Where is the starter on a 1999 F-350 Power Stroke?
starter motor is on the passenger side at rear of engine where the engine and bellhousing join
Why doesn't my 1999 Dodge Ram 2500 with a Cummins diesel not crank Have new alternator batteries are fine and I get good voltage to the starter?
If yo have power to both wires at the starter when trying to crank, the starter is failed.
Where is the starter location on a Pontiac Sunfire 1999?
The solenoid/starter motor assembly is installed on the lower part of the engine next to the transmission bellhousing
Where is the starter location on a 1999 silverado?
At the bottom of the motor, on the passenger side, next to the oil pan.
Where is the fusible link on 1999 Saturn SL?
It is between the alternator and starter, on the firewall side of the engine, nearer to the passenger side of the car.
How do you remove a starter on a 1999 Camero?
disconnect the negative side of the battery. raise car and from underneath, disconnect the solenoid wire and battery cabble from the starter motor solenoid,remove the 2 starter motor boltsremove the starter and note the position of the starter shim if equipped. some cars don't have it. installation is the reverse.
Where is the starter motor located on the 1999 Oldsmobile Delta 88?
it is in the front of the engine follow the + wire from battery
Why will my 1999 cougar won't start?
If it runs for a little while then dies it could be your alternator.. If it ticks or just does nothing its either your battery or starter.
1999 Chrysler Town and Country starter installation?
To install the starter, hold the starter motor spacer in position, install the starter motor-to-transaxle bell housing bolts, tighten it, and engage the solenoid wiring connector onto the terminal. Then, connect the B+ wire, tighten the retaining nut, lower the vehicle, connect the negative battery cable and verify starter motor operation. ÊÊ
