Best Answer

on the trans

User Avatar

Wiki User

โˆ™ 2006-04-06 05:20:45
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the backup light switch on a 1996 ram 1500?
Write your answer...
Related questions

Where is the backup light switch in a 1996 Saturn sl2?

The backup switch is on top of the transmission directly below the battery. @ wires to it

Where is the backup or reversing light switch on a 1996 Chevrolet Camaro automatic?

look down on the tranny itself.

Do 1996 dodge ram 1500 s have a inertia switch on the fuel pumps if so where is it?

No, a 1996 Ram does not have an inertia switch.

1996 Jeep Cherokee backup lights do not come on?

its the safety neutral switch

How do you replace neutral safety switch on 1996 vw jetta?

The combination neutral start and backup light switch is mounted inside the shifter housing. Remove the screws holding down the shifter housing and remove the switch. Adjust the switch by moving it on its mounts.

Where is the backup light switch on a 1996 Dodge Neon 2.0L automatic?

switch is located on front of tranny,look for plug with 3 wires.i just fixed mine and had to remove battery and tray to access part.good luck

Where is the backup light switch located on a dodge 1996 2500 4x4?

ON my 1996 Dodge 2500 it is on the drivers side. On the transmission housing just above the pan gasket and around where the linkages all intertwine an connect to the housing.

Where is fuel reset switch for 1996 Chevy Tahoe 1500 series?

Chevy did not use a reset / Inertia switch on there trucks.

How do you replace the brake light switch on a 1996 suburban?

Look under the dash on the 1996 suburban, and locate the brake light switch on the brake pedal arm. Remove the switch nut, and slide the switch out. Unplug the wires from the switch and install the new switch.

Security Light is On for my 1996 Oldsmobile Cutlas supreme?

where is the brake light switch for 1996 Oldsmobile cutlas supreme

2004 hemi fit in a 1996 ram 1500?

Not an easy swap. You will need the engine, trans, computers, wiring, radiator, abs sensors, brake light switch, accel pedal switch,....... out of the 2004 to get the engine to even run.

Where is inertia switch on a 1996 dodge ram 1500?

Dodge does not use inertia/reset switches.

Where is your brake light switch on a 1996 Geo Prism?

The break light switch is located on the backside of the break peddle arm.

Where is the hazard light switch in Toyota Corolla 1996?

on your dash,

Relay switch on a 1996 gmc jimmy?

There are several relay switch is on your 1996 GMC Jimmy. The brake light relay switch can be found below the dashboard in the engine compartment.

Where is fuel shutoff switch located on 1996 dodge ram 1500?

It does not have a reset or shut off switch. The fuel system is computer controlled with relays.

Where on the transmission is the reverse light switch located for a 1996 Plymouth Voyager?

the reverse light switch is usually mounted on the shifter inside the car.

What powers the cruise control on a 1996 jeep Cherokee?

The engine computer through the brake light switch.The engine computer through the brake light switch.

Where is the rverse light switch on 1996 dodge ram 2500diesel?

On the top of the transmission.

Where is the fog light switch on a 1996 Chrysler sebring convertible?

On the turn signal indicator arm. Switch on the headlights, make sure the high beam is off, then pull out the rotating light switch.

How do 1996 gmc Yukon brake lights work?

The 1996 GMC Yukon brake lights work by receiving power from the brake light relay switch. The brake light relay switch is connected to the brake pedal.

Where does the reverse light wire run in a 1996 ford econoline 350?

The wire should go from the backup switch on the trans through the firewall then it runs under the step well usually under the drivers door and then along the inside of the van to the back

How do you replace head light switch 1996 ford explorer xlt?

the back one

Where is fog light switch on 1996 dodge ram?

On the upper dash right of the steering wheel next to the overdrive (OD) switch

Where is the reset switch for check engine light on 1996 Geo Tracker?

There isn't a reset switch. The light is reset with a scan tool after the cause of the trouble code has been repaired.