Nissan Maxima

Where is the bank 1 camshaft sensor in a 2004 maxima located?

282930

Top Answer
User Avatar
Wiki User
Answered
2011-09-19 21:39:05
2011-09-19 21:39:05

On a 2005 Nissan Maxima where is the Camshaft Position Sensor (Bank 1) located?

123
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Did you figure out where this sensor is located


the camshaft sensors are located on the back of the heads under the air cleaner duct.


On a 2004 Chevy Astro, the camshaft sensor is located in the front of the engine. It is on the left side of the timing cover behind the camshaft sensor.


where is the crankshaft position sensor on a 2004 maxima


where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl



The camshaft position sensor is located on the end of the cam. When you open the hood look at the piece that you put your oil into. Follow that all the way to the right and on the end you will see the sensor. All it is is two bolts and a plug.


The sensor is located directly above the crankshaft pulley. The camshaft sensor also connects with the crankshaft position sensor.


the camshaft position sensor on an 04 pt is located on the right side of the engine, towards the top (looking at it from the front), directly in back behind the oil dipstick on a non-turbo


The camshaft position sensor is mounted on the front of the 5.9l engine. It is at the top of the timing cover, on the back of the flange.



Look underneath the engine where the serpentine belt is located, you can see it by a toothed round gear, it works as a magnet.


CAMSHAFT POSITION SENSOR IS LOCATED AT REAR OF CYLINDER HEAD ON BOTH THE 2.0 AND 2.4. IT'S FARTHER BACK THAN THE IGNITION COIL, HIGHER UP THAN THE ENGINE OIL PRESSURE SWITCH.


on the left handside (driver side) under the throttle body


The three conduit plug directly to the left of your spark plugs is where the sensor is. Be sure you have an E8 socket available to remove.


It is located on the FRONT of the motor where all the belts are below the valve covers height aprox. 3-5 inches with 1 or 2 10mm bolts holding it in and ofcourse a plug on wire. Def Close to top of engine...........




Where is the temperature sensor located on a 2004 duramax diesel?


It is mounted on the passenger side/right side in the timing cover. one bolt holds it in place.


The Crank position sensor is located on the right side behind the wheel about midway up the motor eaiseier to get to from the bottom with 10mm socket one bolt


No Camshaft Position Sensor Circuit Failure


Where would the knock sensor be located on a 2004 mazda 6?


One of the sensors is located on top of the motor by the passenger side it looks too small but is one part inside the motor.


where is the oxygen sensor in a 2004 astro van



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.