Ford Windstar

Where is the block heater in a 1998 ford windstar?

012

Top Answer
User Avatar
Wiki User
Answered
2014-08-21 11:01:39
2014-08-21 11:01:39

The block heater plug in on a 1998 Ford Windstar is in the engine compartment on the passenger side of the vehicle. When lifting up the hood, look on the left for a small hose that is coiled up at the very front, above the passenger headlamp. The block heater itself is plugged into the front of the motor on the passenger side.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


Remove and engine block expansion plug. Insert the block heater. Seal the block heater. Attached the wiring harness to the block heater.


Install block heater in lower rad hose .



Backside of the engine in the center freeze plug :0)


The "Related Question" below is an extensive discussion on the 1999-2003 temperature control valve / heater control valve. It is likely the information will be similar to the 1997 / 1998 Windstar


Replace freeze plug in a 1998 ford windstar ?


It is inside the oil pan on the bottom of the engine block.


A 1998 Ford Windstar would use refrigerant 134a


where does the engine block heater go in my 2007 ford focus


The 2007 Ford escape engine block heater is located on the right hand side of the engine block. You can follow the block heater cord to the block heater.


where is block heater cord for 2008 ford escape


The ford probe gt does not have a block heater block heaters are normally on a desiel Engine


Maybe it's bad. Have you tried changing it? Sound logical to me.


block heater on a ford diesel is actually not a block heater but an oil heater this heater is located on the back right side of the oil cooler on side of engine under the exhaust manifold a block heater in an engine actually is in the block


Ford sucks... i paid for a block heater but ford will not install it after I pointer out that there was not one installed But any thing but a ford..


On a 1998 Ford Windstar : The 3.8 liter V6 engine ( and the 3.0 ) has a timing CHAIN


On a 1998 Ford Windstar : ( # 16 / 20 amp )


How do you replace a heater core in a 1998 ford expedition?"


Hey there,If you stand in front of your Windstar and look at the steering wheel, follow it right down passed the hood almost the ground. There will be a tiny door you can open big enough for an extension cord. Good luck!


Not likely - the 1999 Windstar was a rather significant updating of design compared to 1995-1998 models.


The blower on the back heater may need to be replaced on the 2000 Ford Winstar.


Temperature is controlled via an electric actuator motor.See "Related Questions" below for more all about Windstar rear heating / cooling systems.


The radiator cooling fans are turned on when the heater control is set to defrost.This makes for better and more effective defrosting of the windshield


On a 1998 Ford Windstar ( 3.0 and 3.8 ) firewall 1-----2-----3 4-----5-----6 front of vehicle > driver


same way as any other block heater... ========================================================== Your Ford Ranger block heater is just like the heating element in an electric kettle . As long as the electric block heater is plugged in to an electric outlet that has power to it , the block heater keeps on heating the engine coolant if everything is working correctly



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.