yes, same motor
Remove the wiring harness from the back of your 1999 Chevy Monte Carlo blower motor. Remove the blower motor retaining bolts. Remove the fan on the front of the blower motor. Reverse the process to install the new blower motor.
on the blower houseing beside the blower motor
To check the fan relays on the 99 Malibu, you can swap the relay between the AC blower and the fan.
Blown fuse, bad blower motor switch, blower motor itself, or a defective blower motor resistor pack.
Yes. '99-'01 same
The blower motor is drawing to many amps, replace the blower motor.
marks timing chain 99 Malibu 2.4
Short in the circuit somewhere. Try unplugging the blower motor, closing the circuit with a test lead or test light, and seeing if it blows then. If not, the problem would seem to be in the blower motor itself.
On the passengers side under the glovebox near the side kick panel.........
Yes. '97-'05 the same.
Under the hood, on the passenger side of firewall, near the blower motor.
the thermostat is in the coolant cap
below the glovebox
Blown fuse, bad motor, bad blower motor switch, or a defective Blower Motor Resistor Pack.
99% of the time, the blower motor relay, or resistor block,will be bad if the fan motor only works on high speed.
drivers side, tucked behind the exhaust tunnel on the side of the motor, follow the radiator hose to it. they are tuff to change
A common cause for this is a burned out blower resistor. Tech JK --------------------------
Check to see if you are getting power and ground to the blower motor - if so blower motor is bad. If no power possibly fan switch or selector switch Also check the blower motor resistor, found in heater plenum.
Your blower motor is going out. Be prepared to replace it soon or it will just quit working all together.
Yes. Yes. Yes.
I am pretty sure that a 97 and 99 are the same. On a 99 Tahoe the blower motor resistor pack is on top of the air box. Remove the glove compartment door, the blower itself will be on the right side. All the way to the far left on top of the air box there is a plug. Unplug and remove the 2 small screws. With some manipulation the resistor pack will lift out.