Heater Cores and Blower Fans
Pontiac Sunfire
Chevy Colorado

Where is the blower motor located on a 2002 Pontiac sunfire?

434445

Top Answer
User Avatar
Wiki User
2006-11-17 05:44:50
2006-11-17 05:44:50

The Blower motor should be under the dash on the passenger side. It is easily accessible and can be removed by taking out the three screws and wire harness.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

the blower switch itself is located in the instrument panel. it adjust the speed of the blower. the blower resistor, if that is what you are looking for,is located beside the blower motor under the pass. side of the dash

User Avatar

Resistor is located behind the blower motor assembly.

User Avatar

Try looking under the passenger side foot area. The blower motor will be there, and the blower motor resistor should be there also, will have a wiring harness and I believe 2 bolts holding it.

User Avatar

Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.

User Avatar

Most are up underneath the dashboard. Turn on the heater blower motor and listen where the sound is coming from. The heater core is behind that sound.

User Avatar

The heater blower motor in a 1995 Pontiac Transport is located on the passenger side of the engine compartment. It is on the firewall near the hood hinge.

User Avatar

Blower motor fuse is blown. Blower motor resistor burned out. Blower motor switch bad. Blower motor bad.

User Avatar

Your wiring is probably messed up, happened to me. Locate the wires from the blower to the controls check them and replace as needed. Assuming no wiring problem check and replace the blower motor resistor.

User Avatar

the resistor is directly behind the blower motor under the dash

User Avatar

On my 2002 Sunfire it's under the dash on the passenger side.

User Avatar

on the back of the motor wright below the crank sensor

User Avatar

The blower rheostat on a 93 Pontiac Grand Am is located inside the engine bay, just to the right of the blower fan housing. It is almost directly behind the trans dipstick. It isn't that hard to replace.

User Avatar

# Disable the airbag system before working # Remove the lower right dash insulator panel for access to the blower motor # Disconnect the electrical connector from the blower motor and remove the three screws from the blower housing # Pull the blower motor and fan straight down # To remove the fan from the blowr motor,use a narrow punch and tap the shaft out of the fan assembly.

User Avatar

I am no expert; but, according to my Montana repair manual, the blower motor resistor is located under the dash on the passenger side. It can be accessed from inside the car. It's located behind the fan motor

User Avatar

Blower motor resistors are usually located close to the blower motor.

User Avatar

The heater blower motor itself is located under the hood on the passenger side of the car.

User Avatar

Blower motor speed resistors are generally located close to the blower motor.

User Avatar

in side under the dash on the passener side of the car

User Avatar

its behind the blower motor under the passenger side of dash

User Avatar

where is the blower motor located a a 1997 oldsmobile achieva

User Avatar

The coil pack on a 2000 Pontiac Sunfire is located behind the air intake hose. Just behind where the air intake hose connects to the top of the motor is where the coil pack is on this vehicle.

User Avatar

usually the blower motor resistor pkg. located on or near the blower motor

User Avatar

The Blower Motor has a resistor attached to the blower motor itself. I'm not familar with a relay for the motor. I think you have to remove the Blower Motor itself to get access to the resistor. The blower motor is under the dash on the passenger side. It's like 3 maybe 4 bolts to remove.

User Avatar

The blower motor on a 1997 Pontiac Bonneville is located next the evaporator core. It will be mounted behind the glovebox on the passenger side of the vehicle. Remove the glovebox, mounting hardware, and sensor clips. The blower motor will be able to be replaced.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.