0
look under the dash where the fuses are. or it can be under the hood where the box of fuses are located. look under the dash where the fuses are. or it can be under the hood where the box of fuses are located.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is blower motor relay for 2003 Ford F150?
under plastic kick panel under middle of dash
Where is blower motor resistor for 1995 Ford F150?
it should be next to the blower motor
If when changing a blower motor on an 1988 Ford F150 the blower still does not blow and the fuse has been changed what could be the problem?
Check the blower motor resistor/relay pack usually under the hood connected to the blower motor. You can start by using a multimeter and see if you are getting voltage to the blower motor electrical connector. It should read between 12 and 15v. If not then most likely the resistor/relay need to be replaced.
What causes the AC blower not to work on a Ford F150 V6?
Check fuse if ok Check to see if getting power to fan motor - if ok motor needs replacing - if not may be switch or relay
Blower motor location 1977 ford f150?
The blower motor should be under the hood. It is on the passenger side and bolts into the back of the heater housing.
Install blower motor 2004 Ford F-150?
instalation of f150 blower moter which way does it mount?
Why does the heater fan on a 1993 f150 only work on low speed have already replaced blower motor same result?
You have a bad blower motor resister..........
Why does blower fan only work on high on Ford f150?
Blower Motor Resistor is bad. 20.00 part at AZ.
Why does your 1992 f150 heater motor only work on high?
Most likely and bad blower motor resistor.
Where is the turn signal relay located on a 1999 Ford F150?
16
How do you replace the blower motor resistor in a 1999 Ford F150?
it is located and accessible under the dash by the front passenger floor board. need 8mm nut driver only. easy
Where is the blower motor resistor in 2005 ford f150?
it is behind the glove box for the 2004-2008 F150 truck. There is a connector with four pins in it and this part is held in place with 2 bolts only. I is more on the right hand side of the blower motor assembly
