answersLogoWhite
Heater Cores and Blower Fans
Nissan Trucks and SUVs
VW Jetta
Grand Prix LE

Where is the blower motor resistor on 1994 Nissan SE pickup?

252627

Top Answer
User Avatar
Wiki User
2011-09-13 10:33:41
2011-09-13 10:33:41

if you remove the glove box you will see a metal panel.There are a number of Philips(star like) screws.Take these screws out and remove the metal panel,behind that panel you will find the blower motor resistor its about 2 inches wide by 3 inches high it also has 2 Philips screws fastening it into the plastic heating ducts.good luck

1

Related Questions

User Avatar

The 2001 Nissan Quest blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.

User Avatar

The blower motor resistor is mounted next to the motor on the passengers side under the dash..............

User Avatar

To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.

User Avatar

Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad. If no, then the resistor, relay, or fuse is bad.

User Avatar

Should be near or attached to the blower motor

User Avatar

They are generally found close to the blower motor.

User Avatar

how to replace heater fan resistor on Nissan Sentra 2003

User Avatar

It might be your resistor, does it work on 4 but not on 1,2,3? If so, you need a new blower motor resistor.

User Avatar

One can replace blower motor resistor on 2003 Nissan altima by removing the old using spanners and replacing it with a new one.

User Avatar

Most cars have the blower resistor located close to the blower motor.

User Avatar

The 2005 Ford F1 50 pickup truck blower motor resistor pack can be found on the firewall in the engine compartment. The blower motor resistor pack is on the passenger side of the firewall.

User Avatar

Under the hood, passenger side firewall, not far from the blower motor.

User Avatar

The blower motor resistor on a 1993 Nissan Altima is behind the glove compartment on the passenger side of the vehicle. To access the blower motor resistor, the glove compartment can be removed by lowering the bottom as much as possible and removing it from the hinges.

User Avatar

change the blower motor resistor. done deal.

User Avatar

A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.

User Avatar

Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.

User Avatar

You will need to change the blower motor resistor by finding it near the air duct system. You will take the old resistor off and replace it the same way.

User Avatar

it is probably in the blower motor, at least that is where it is on the 1995 truck. take out glove blox/ remove black metal cover behind glove box. It is the white connector in plain site..

User Avatar

The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.

User Avatar

More than likely the blower motor speed resistor burned out.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.