I believe that one is behind the glove box door. Once you drop the door you should be able to get at it.To be sure you can check with your Chevy dealers parts department and they can print out a copy of its location for you.
Have your blower motor resistor or blower motor checked out
The blower motor resistor assembly is located to the right of the blower motor. The blower motor is located in the engine compartment on the passenger side of the firewall.
heat not working
Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.
Should be near or attached to the blower motor
Should be behind the glove box. The blower motor speed resistor is located under the hood, on the firewall, passenger side, close to the blower motor.
right next to the blower unit.
It is usually ( at least on a 2000 Ranger) locted on the blower motor housing in the engine compartment.
Check for a bad blower resistor at blower motor
It is located on the passenger side of the engine compartment firewall next to the blower motor.
Blown fuse, defective blower motor resistor pack, defective blower motor, or loose or disconnected wiring.
The blower motor resistor that sits behind the blower motor itself all the way against the firewall.
I am no expert; but, according to my Montana repair manual, the blower motor resistor is located under the dash on the passenger side. It can be accessed from inside the car. It's located behind the fan motor
There is a removeable panel below the glovebox. It is in front of the blower motor against the firewall. It has a wire connector from the loom and then it plugs into the blower motor
Defective Blower Motor Resistor Pack.
You need to replace the blower motor resistor located near the glove box.
First locate the resistor, it is under the hood, on the firewall, passenger side, close to the blower motor. Unplug the wire connection and remove the three small screws holding it in place, then remove the resistor.
take the blower motor out you will see two plugs one for the motor and the other for the resistor two screws hold it in place looks like a motherboard price for new one is about 30.00
The resistor is located on the duct work under the dash. Sitting in the passenger seat facing forward it is to the left of the blower motor mounted on the duct work firewall.
Assuming you're talking about the blower motor, because the blower motor resistor is faulty, and needs to be replaced. On the high setting, it doesn't go through the resistor - on the other settings, it does.
replace the blower motor resistor. it is located on the firewall near the heater hoses.
Behind the control panel for the center console.
Well it is apparent that all is not ok. The speed of the blower motor is controlled by the blower motor speed control switch and the blower motor resistor pack. One of those two items is your problem. I would bet the blower motor resistor pack is defective. The only way to know for sure is to replace it.
If it has only high speed, the blower motor resistor has to be replaced to get all speeds back.
resistor for fan blower is in back of glove box, beside the blower itself.