fuse, wiring, blower motor, blower motor switch, blower motor resistor
The blower motor resistor is generally located close to the blower motor.
Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.
The resistor is to the left of the blower, it is very hard to get to. You'll have to almost stand on your head to change it.
Blower resistor is under the glove box. It is diamond shaped with 2 screws holding it in.
the resistor is gonna be right off the blower motor attached to the blower motor by a wire harness should be by the heater core
it is the switch you use to turn blower up and down.if you mean resistor it is in the heater box next to blower motor
Under the steering wheel panel
replace the blower motor switch
Defective blower motor resistor pack.
The blower resistor assembly is located on the heater case to the right of the blower motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
The blower motor resistor is located under the passenger side glove box by the foot rest, easily accessible with a standard ratchet.
it could be the blower switch
The blower motor resistor is located on the lower right side of the HVAC unit housing inside the the vehicle under the dash on the passengers side........
Blower Motor Resistor Pack is defective.
The Blower Resistor is on the Passenger side of the car. Look under the glovebox to the right. There is a cap for the blower held on by 3(?) Screws. Pull this off. You will see wires going to the Resistor. Two screws hold in the blower resistor. See picture here. its #6 http://www.kiausaparts.com/catalog/results.asp?section=6150A&uid=610413&formname=sectionform
You have a bad blower resistor. it is located directly behind the blower motor on the passenger side of the vehicle. You must first disconnect blower motor from bad resistor. Lower and remove blower. It won't be easy but remove the screws holding the resistor, disconnect the resistor and remove it. Cost is approximately $40 for a new one.
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.
Either it's the switch on the dash (unlikely) or the blower motor resistor pack (very likely). The resistor pack is usually easy to replace.
On the passenger side, bend under the dach, disconnect the coupler, remove the screw of the small hexgonal part and remove the blower motor resistor!
The blower resistor has failed.The blower resistor has failed.
The blower motor fan cools the resistor so the resistor is usually located close to the blower.
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal