Heater Cores and Blower Fans
Jeep Liberty
Jeep Wrangler Sport

Where is the blower resistor on a 2002 Jeep Liberty?

575859

Top Answer
User Avatar
Wiki User
2007-02-06 21:34:33
2007-02-06 21:34:33

It is behind the glove box. Need to remove the glov e box by opeining and slide it then you will see a conector with, I think, 5 wires, it goes to the ventilation system, two screws and it comes out, looks like a credit card circuit board covered with a coating. put new one in. -- from jeepsunlimited.com I just changed mine. Open your glove box 1/2 way, hold the sides in to open it all the way and slide it out. Just like jeepsunlimited described, you will see your part. It is held by two 5/16 bolts. Take the bolts out, turn the entire thing around. You will see a red clamp, lift that with a flathead screwdriver, lift the black part the red clip was holding. PULL! It is really hard to get out! - thanks to jeepsunlimited for telling us where it was!

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you chage the fan resistor in a 2002 jeep liberty?

User Avatar

Replace the Blower Resistor which is located behind the glove compartment. This is a common problem.

User Avatar

If you are missing the lower speeds but still have high speed, the resistor is bad.

User Avatar

You probably have a faulty blower motor resistor. I believe it is located on bottom of heater box. This I also believe a dealer item.

User Avatar

maybe blown fuse or the connection in the blower resistor is damaged or the blowre resistor module is burn out the blower resistor is located in front passinger under the dach boared

User Avatar

Where is the resistor on 2001 jeep wrangler

User Avatar

What fuse number for 2004 Jeep Liberty blower motor?

User Avatar

it is under the clove box behind the blower motor you will see it if you look its a black box

User Avatar

Failed blower resistor. It is located under the dash on the passenger side.

User Avatar

possibly blower motor some libertys had a recall call your dealer and check also could be the blower motor resistor

User Avatar

The blower resistor is behind the glove box door.

User Avatar

If it works on some speeds and not others, the most likely problem is a defective Blower Motor Resistor Pack. It is located near the blower motor.

User Avatar

A 2002 Jeep Liberty has a timing chain.

User Avatar

The resistor is to the left of the blower, it is very hard to get to. You'll have to almost stand on your head to change it.

User Avatar

Blower resistor is under the glove box. It is diamond shaped with 2 screws holding it in.

User Avatar

it's behind the glove box (remove) and it is in the airstream -- look for the wires going to it and remove same.

User Avatar

IT could be one of three things. 1- bad motor, 2-bad resistor, or 3- bad relay.

User Avatar

What distributes power to spark plugs on 2002 jeep liberty

User Avatar

Blower motor resistors are generally found nearby the blower motor.

User Avatar

the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine

User Avatar

Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch . Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor. Remove the two screws that secure the blower motor resistor block to the HVAC housing. Remove the resistor block from the HVAC housing............

User Avatar

Either the switch itself is defective, or more than likely the Blower Motor Resistor Pack is defective. This is a common symptom of a defective Resistor Pack.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.