the 1989 Honda accord lxi has a brake lamp light on the dashboard, if the brake lamp light is on, this means you have a brake/tail light out or disconnected
it's attached to the r/s tail light assy.
2004 Honda Accord Brake Light Bulb Numbers - See sources and related links below.
On a 1994 Honda Accord, the brake lamp comes on when a tail light is no longer working. The burned-out bulb needs to be replaced. The brake lamp will not come on after the bulb is replaced.
If you are referring to the brake light then the brake light switch is stuck.
If a 2000 Honda Accord gas light stays on the fuel sensor may be failing. Running a diagnostic tool will show if the fuel gauge sensor is malfunctioning.
IT USUALLY MEANS LOW BRAKE FLUID. JOSE It means the brake lamp sensor has detected a burned out bulb. This can also happen if you disconnect your high mount brake lamp to connect the circuit to a spoiler mounted brake light without changing the sensor. -- dws
just had oil change on saturday. no problems. now brake lamp light on 2000 honda accord ex
If a gas light stays on a 2000 Honda Accord the fuel sensor is malfunctioning. Replacement of the sensor is advised as the car will run of safe mode if the ECU believes it is low on gas.
Low brake fluid level or Parking brake not released completely
It means one of your rear brake lights are out. Not the tailights but the brake light(s).
Mounted on the upper part of the brake pedal.
Adjust or replace the brake light switch.
you take it apart and fix it
My 1992 Honda Accord Brake Lamp came on several times after I had the Master Cylinder replaced. Turns out the fluid had gotten low. Once I refilled the fluid level, the light stopped coming on.
Defective or misaligned brake light switch.
chake ur manual
Look inside the trunk under the light for bolts to remove the light.
it may indicate that the brake fluid is low
check for blown brake light bulbs and broken wires. also check brake light switch on brake pedal
In the rear tail light assembly one for each side.
The passenger side rear brake light sensor is a little black box (approximately1/4" x 2") that lis attached by two screws to the inside of the passenger side rear tail brake lamp. It has six wires hooked to it and one (grn-wht) feeds the third (upper) brake light. The driver's side sensor has only 5 wires. There is no black on the driver's side. So, they are not interchangeable.
well you change it from the outside
there is a problem in your brake system. take vehicle to a brake mechanic
If the brake like of a 1991 Honda Accord turns on the vehicle will need the brake systems checked. Another thing to look for as well is the fuse for the e-brake.