Auto Parts and Repairs
Dodge Durango
Toyota Corolla
Honda Accord EX

Where is the button on a 2004 Toyota Corolla to reset the malfunction indicator lamp?

424344

Top Answer
User Avatar
Wiki User
Answered
2005-09-09 18:14:34
2005-09-09 18:14:34

Take the car back to the dealer. Push in on the oddometer trip reset button, turn the ignition on, and hold the button until the display goes to 00.0.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Where is the fuel pump inertia circuit breaker located on a 2008 Toyota Corolla

It is on above of right vent the button is there on the top of middle vent console

The little red button on the driver side is for overdrive.

its on the shift lever of my dx where your thumb hits the lever

The Flasher indicator relay is build build into the end of the Hazard warning button.

while the time is showing on the display, hold down the AM/FM button and press button 1 to advance the hours and button 2 to advance the minutes.

Turn the ignition key partially change display to "Trip A" and turn ignition OFF. Press the trip reset button and then turn the ignition key partially. Do not start engine. Hold reset button down until light goes off.

Look for a fuse on the left-panel below the driver. It controls the inside middle stop-brake light and the transmission button.

2001 Toyota Corollas do not come preinstalled with fog lights. You will need to install them yourself. Many of them do come preinstalled with the wires, which makes installation easy.

there will be a small button below the gear shift stick.... on the stick itself.. just click that button.....

is to reset your tire light in panel... Look this video: https://www.youtube.com/watch?v=sh0A5QCgwAU

Yes you can change the horn button,but make sure that you dont cross or touch any of the other wires other than the horn wire.

How do you reset maintenance reminder light on 2008 Toyota corolla? For what it is worth: To reset the Maintenance Required light on my 2007 Toyota Corolla: 1) Set your trip meter to the odometer setting (in other words, not Trip A or Trip B) 2) Hold down trip meter reset button and turn ignition to off. 3) While holding down the trip meter reset button now turn the ignition to on. 4) Keep holding down button until Maintenance Required light shuts off. Note: One some other Toyota models you hold down the Trip A meter rather than the odometer. Hope this works for you.

Turn ignition key till time shows Hold MUTE button Press 1 for hours Press 2 for minutes

You start the car first then there is a button on the dashboard next to the steering wheel hit that and it'll enable the seat belt charm.

there is a button near the hood release. Press it for a few seconds and it will reset the tire pressure indicator alarm.

To replace the horn on a 94 Toyota Corolla, you will need to remove the horn pad from the steering wheel. Once all screws have been loosened, you can lift the pad and replace the inner button, then just put the horn pad back on.

set your mileage on your actual mileage reading, not a setting measuring your trip. Keep hold down the button until it resets itself.

You have to hold the tire pressure button down until the light starts flashing, after 5 seconds press the button again( do not hold it). This will reset the system, and recalibrate it to the new tires

un install one of your battery cables for about 5 min. or you can try hoding the trip button and start the car

There is a button on top of the indicator, Just push it down.

remove small cap in top right corner of gear indicator panel. depress small button and shift


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.