answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2010-09-02 12:16:53
2010-09-02 12:16:53

It is in the distributor.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.


The camshaft position sensor on a 4.3L engine would be in the distributor.


A camshaft position sensor reads the location of the camshaft and sends that information the engine computer. This is needed for fuel and ignition timing.


It is located in the back by # 6 cylinder on top of the motor between the heads.


The camshaft position sensor is most likely located on the cylinder head of the engine. The location could vary depending on the manufacturer.


The camshaft position sensor on your 2002 automobile is located on the front of the camshaft. You will need to remove the front engine cover to access the sensor.


model year and engine size are relevant to the question.


The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.


The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.


The camshaft position sensor is located on the timing chain cover at the front of the engine.


The camshaft position sensor for the 3.0L V-6 engine is located in the distributor. Good Luck!


The camshaft position sensor on a 2001 ford mustang is located on the front of the engine. It is behind the power steering fluid reservoir.


The camshaft position sensor for a Mercury Mystique is located on top of the motor. It is bolted in the same place where older versions of the engine had a distributor.


Do you have the 3.4l or 2.4l engine, the camshaft position sensor for the v6(3.4l) is located under the power steering pump


The camshaft position sensor is located under the hood, beneath the engine cover. The engine cover must be removed with a wrench to access the two sensor banks and their wiring harnesses.


The camshaft position sensor is bolted on the engine near the transmission. It is on the firewall side, and can be reached from the top.


It is located underneath the intake manifold near the rear of the engine.


I'm not sure which engine you have, but, the 2.0 has the camshaft sensor on the drivers side of the engine, right in front of the distributer


The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.


The Camshaft Position (CMP) sensor is located on the passenger side of the engine and is accessible after removing the right front tire-2.2L engine.


according to my Haynes repair manual the camshaft position sensor for the 4.0 L OHV engine is located at the rear of the engine block, on the top of the engine block



The camshaft position sensor on a Dodge Ram 2500 5.7 engine is located at the rear of the camshaft near the top of the motor. It monitors the motion of the camshaft and constantly updates the vehicle's computer.



At the back of the engine, looks like a distributor!



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.