Where is the camshaft position sensor located on a Chevy S-10 22L 4-cylinder engine?
On a '99 S-10 2.2, the camshaft position sensor is located on the passenger side of the engine block, about halfway back. You can access it through the wheel well (remove the wheel first, and be sure to use a reliable jack stand). It is directly in front of the coil pack, (about 2 - 3 inches). It has a 3-prong plug. Be very careful when trying to remove it. (I broke the crankshaft sensor off, almost had to pull the engine. I ended up drilling two holes in it and pulling it with a small needle-nosed vice grip.) Don't try to pry it out with a screwdriver. Get ahold of it with vice grips and pull with a twisting motion.
How does a camshaft position sensor work and how can you get it to set a code without unplugging it?
the cranshaft and camshaft position sensor. the engine speed and cranshaft position information is supplied frome a sensor which is usually situated at the front or rear of the cranshaft.note that distributor-located engine speed sensor are generally being replaced with cranshaft-located sensors,as worn disributor drives and associated components can effect the accuracy of the engine speed signal. A camshaft position sensor,or cylinder identification sensor is used to determin the engine cycle position the information is…
The Camshaft Position Sensor is located under the Rotor within the Distributor. Remove the Distributor Cap (two screws - one in front the other in back), located at the rear of the engine, then remove the Rotor (two screws). The Camshaft Position Sensor is located under the Rotor mounting housing. The engine will need to be turned (hand cranked using a wrench - large nut behind the cooling fan) to position the Rotor mounting housing…
Take plastic engine cover off, which is on top of engine. You will find 4 Allen screws holding the cover in place. The cover is mounted on top of the valve covers. Camshaft position sensor is located to the left of the engine...(looking at engine) you will see two cam gears, sensor is located between the gears. Good luck!
The Model and Year of Jeep and engine size is required information for a specific answer. The Crankshaft Position Sensor (CKP or sometimes CPS) is located on the transmission bell housing. The Camshaft Position Sensor ( sometimes called the Camshaft Pickup or CPS) is located inside the distributor. If your Jeep has the coil-on-plug distributor-less ignition, it still has a Camshaft Sensor in the same location as the distributor would be located.