Its under the harmonic balancer cover. You can see the wiring on the right (front) side of the cover. Pull the harmonic balancer to replace it, make sure you line-up the teeth right in the magnetic pick-up.
The camshaft position sensor on a 1992 Buick Regal looks like the end of a ratchet.
it should be in the distrubator
Some of the 1992 Rangers had the camshaft position sensor on top of the engine in the same hole where the distributor used to be. Some Ranger engines did not use a camshaft sensor at all.
inside of the distributor
The camshaft position sensor, which is located inside the distributor, is a pretty easy component to test on the 1992-1995 5.2L/5.9L Dodge Ram 1500/2500 pickup.
where does the camshaft sensor go in a 1992 Cadillac Sedan Deville?
Answeron the rear of the engine, towards the transThe cam sensor is in the distributor.
It should behind the crankshaft pulley, just next to the timing belt gear.
On the front of the engine block on the drivers side of the engine. Right below the valve covers.
If you have the V-6 engine it is on the side of the engine block closest to the firewall just above the oil pan about 2 inches up and about middle of the block. This is the crankshaft sensor this car does not have a camshaft sensor On the 4 cylinder it is below the coil pack same side of the engine as the V-6. And again this is a crankshaft sensor not a camshaft sensor. Hope this helps
Under hood, passenger side, lower engine area, below water pump, mounted on timing cover.
It is located lower right hand side of engine unfortunately you will have to remove the distributor assembly to install as it is integral.