i have a 99 3,4 litre and it is located behind the harmonic balancer which is located on the timing cover. you need to pull front passenger tire and the plastic shroud and you will see the balancer. you take that off and on the right side you will see two small bolts that hold on a small device about two inches long. that is the sensor, follow it up and it will unplugg fat the top. it is actually pretty easy to change!
Cam sensor location 02 pontiac montana 3.4
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
The camshaft position sensor on a 1998 Pontiac Grand Prix is located behind the rear bearing of the camshaft. It constantly monitors the rotation of the camshaft and relays this information to the computer.
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
Did you figure out where this sensor is located
The camshaft sensor is located in the distributor. I believe you have to replace the hole distributor.
Camshaft sensor is located at rear end of rear camshaft(near driver). It is screwed on the little bowl and has a connector attached to it. The little bowl contains the camshaft sensor gear , do not unscrew if not necessary , just replace sensor. Jules
Rear camshaft seal bad. Replace. located behind cam sensor.
Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.
cam position sensor on a 2.3 quad 4 is on the end of the front camshaft housing, on the back of it, it is a round plug.
It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.
It's located on the passenger side under the powerstreeing pump