Actually Dodge Neons are Direct Ignition Systems (DIS) basically meaning it doesn't operate with a distributor like the old systems. Instead they have the camshaft position sensor and the crankshaft position sensor. The camshaft position sensor is located on the end of the head that is on the driver side of the vehicle or on your right as your looking at it. Its right above the transmission bolted to the head with four bolts they should be 10 mm bolts if they haven't been altered.
The camshaft position sensor is on the driver side end of the cylinder head.
A 1996 Plymouth Neon does not have a maf sensor.
The fuel pump in the 1998 Plymouth neon is located inside the gas tank.
The camshaft position sensor on the Neon 4 cylinder is located at the driver's side of the head in line with the camshafts, just below the valve cover
Rear camshaft seal bad. Replace. located behind cam sensor.
not much besides badging and sorts. the Plymouth neon "sport" model is called the expresso, while the dodge neon sport model is the "sport."
Where is the engine management and ignition sensor on a 1999 plymouth voyager?
It does not have a MAF sensor.
I have a 1998 Plymouth Neon and it holds approx. 12.5 gallons.
2006 was the last Neon. The cam sensor was located on the driver side end of the cylinder head.
The coolant temperature sensor on a 2005 Dodge Neon is located on the cylinder head. It is close to the camshaft position sensor.
It tells the computer the rotational position of the camshaft.
are there 2 bolt ot 3 bolt on a starter on 1998 neon
A 1998 Neon uses DOT 3
Camshaft position sensor intermittent.The cam sensor on the end of the head has failed.Camshaft position sensor intermittent.The cam sensor on the end of the head has failed.
The cam sensor is on the driver side of the cylinder head.
how do you put a Plymouth neon back in time 2.0L single overhead cam
transmission/ transfer case
Driver side end of the cylinder head.
Plymouth does not use inertia/reset switches.
Sell it and buy a ferrari!!