answersLogoWhite

0


Best Answer

if you are sure your car has a carbuerator and not fuel injection like all newer cars,the needle would be attached to the topside of the float in the bottom of the carb, its purpose is to slow or speed up fuel flow into the carb. hope i helped, but i think that year of car may be fuel injected, sharris@maplenet.net if you have any questions

User Avatar

Wiki User

โˆ™ 2005-01-31 05:29:51
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the carburetor needle on a 1988 Toyota Corolla?
Write your answer...
Submit
Related questions

How do you do ignition timing on 1988 Toyota Corolla fx?

how to do ignition timing on 1988 Toyota corolla fx


Where is the adjustment needle on a 1988 Toyota Corolla carburetor?

I found a complete diagnostic and repair section on your carburetor at autozone.com. Go to the "vehicle repair guides" section and you'll find it with a little bit of looking. I printed it out and it was 28 pages. I've been looking for the same info for several years. Good luck!


What is the torque specs on head gaskets for 1988 Toyota corolla?

torque specs on head gaskets 1988 toyota corolla 4A-F


Where do you find a Diagram for 1988 tercel carburetor?

You can find a 1988 Toyota carburetor diagram at most Toyota dealerships. The diagram can also be found in Toyota service manuals at your local library.


What type freon for 1988 Toyota Corolla?

R12


Does a 1988 Toyota cressida have a carburetor?

No, its fuel injected engine


Does a 2004 Toyota corolla have a timing chain or belt?

A chain. Every Corolla since 1988 has a chain


How do i rewire a Toyota carb?

i have a 1988 Toyota corolla fx w/ a 1.6 liter manual transmission i am trying to replace carburetor with a reman replacement vapex pt#181-16131 the wiring connection is different what is necessary to do to install properly


What is the vacuum line diagram for 1988 Toyota Corolla?

It is a vacuum line diagram for a 1988 Toyota Corolla. What else would it be. :-) Just playing. You can find one [http://www.themotorbookstore.com/corolla2.html Here]


Where can you find a wiring diagram for a 1988 Toyota Corolla FX?

try www.autozone.com


How do you get the key code for a 1988 Toyota Corolla?

it is stamped on the passanger door lock


Was 1988 Toyota Corolla a good car?

Yes, Toyota has no peers in relaiablity and holding value no matter the year


Where can you find fuel line routing information for a 1988 corolla fx?

You can find fuel line routing information for your 1988 Corolla in Toyota service manuals. The Toyota service manuals can be purchased from most auto-parts stores.


Where is the MAP sensor located on an 88 Toyota corolla?

The MAP sensor is located on the engine compartment on 1988 Toyota Corolla. The MAP sensor can be purchased at any auto parts store.


What is the tire size for a 1988 Toyota Corolla?

The original tire size is 155/80R-13


Where is the ignition module located on a 1988 Toyota Corolla?

Inside the distributor cap under the rotor.


How do you replace the front axel drive shaft on a 1988 Toyota Corolla?

you just pull it out you just pull it out


Where is the fuel pump in a 1988 Toyota Corolla?

it is in the tank follow your rear fuel lines


What year Toyota corolla cars have interchangeable wheels?

Pre 1988 had four lug wheels then in 1987 (1988 model year) Corolla went to front wheel drive and 5 (five) lug wheels. All pre 1988 are the same, and all post 1988 same


How many gallons of fuel does a 1988 Toyota Corolla FX's gas tank hold?

My 1987 corolla fx took 11.4 to fill on a pretty empty tank.


Firing order 2bl Toyota?

What is the firig ordre on a 1988 Toyota corrola deluxe 1.6 engine 2 barrel carburetor 4 door sedan ?


Where is the flasher located on a 1988 Toyota Corolla?

Flashers are normally located under the dash by the steering wheel near the firewall.


How do you change starter on a 1988 Toyota Corolla sedan?

In the back of the engine one bolt is hidden under the air box


What size wiper blades fit a 1988 Toyota Corolla?

The 1988 Toyota Corolla (excluding the FX16) takes 19" drivers side and 17" passenger side replacement windshield wiper blades (and a 13" rear wiper blade if applicable). The 1988 Toyota Corolla FX16 takes 17" on both sides front and a 13" rear. Be sure to always lookup the exact part numbers for the brand of wipers you decide to purchase. This not only ensures the correct lengths but also the correct attachments. See related links below.


How do you troubleshoot a 1988 Chevy Carburetor?

It doesn't have a carburetor.

Study guides

๐Ÿ““
Create a Study Guide