It should be on the bell housing above the hydrolic hose, mine had a rubber cap covering it.
how do I bleed the clutch system in a 2004 ford ranger
well mines not a ranger its a ford f250 super cab 7.5 l now how do i stop the clutch pedle from going to the floor
At the bottom of the radiator, you can see it from under the truck.
how to i change a clutch in a 1993 ford ranger
A person can bleed the clutch on a Ford Transit Van by hooking a bleeder hose to the slave cylinder, placing it into a small jar of hydraulic fluid, and loosing the bleeder screw. The clutch is then slow pressed until no air bubbles are present.
press down on the clutch, keep it pressed down, and have another person loosen the bleeder screw with the clutch depressed, then tighten it back up and release the clutch. Do this several times until you get a steady stream of fluid (with no air in the fluid) and be sure a keep the clutch master cyl. full at all times, because it will lose fluid when you bleed it Note: if the bleeder screw is tore up, you can always loosen the hose where it enters the slave, and do the same process, using the hose inlet instead of the bleeder screw.
This works for any hydraulic system, clutch or brakes. On the slave cylinder is the bleeder screw. Use a piece of tubing that just fits over the screw and put the other end in a container with about an inch of brake fluid in it. With the screw loosened and the clutch master cylinder full slowly pump the brake. One or two complete fillings of the master cylinder should be enough to bleed the system. Make sure the master doesn't run out of fluid in the process. Tighten the bleeder screw and you should be done.
There wont be one on the master but there is one on the slave, it looks like a grease fitting.
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
you don't adjust it. It is a Hydraulic clutch unit. you have to bleed it. There is a 7/16" bleeder valve on the transmission. clay Colorado
On the drivers side of the transmission bellhousing Check out : www . the ranger station . com ( no spaces ) Click on Tech Library Under the manual transmission section they have a good write-up on how to bleed a hydraulic clutch
DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger