Clutches and Flywheels
Geo Tracker

Where is the clutch sensor on a 1996 Geo Tracker?

567

Top Answer
User Avatar
Wiki User
Answered
2008-10-27 22:13:51
2008-10-27 22:13:51

on the firewall under the clutch pedal, It is actually a switch

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


The clutch reservoir on a 1996 Geo Tracker is located in the engine compartment, near the firewall. It stores clutch fluid which is pulled into the system as needed.


The speed sensor for a 1996 Geo Tracker is located on the transmission housing. The speed sensor is important , it keeps track of the tires and delivers the figures to the main system


it has a cable. will not have a clutch reservoir


The 1990 Geo Tracker IAT sensor is located on the top of the transmission. The IAT sensor will be near the back of the transmission.


The IAT ( Intake Air Temperature ) sensor is located on the back of the air cleaner housing.


There is no neutral safety switch it is a clutch position switch ans is loacted in the floor in front of the clutch pedal


Yes it does. I have a 96 geo tracker and it does have power steering.


All 1995 GEO Trackers have a clutch cable that is adjustable instead of a clutch reservior filled with hydraulic fluid.


torque flight transmission


Yes, also search for a Suzuki Sidekick they are the same as well.


The IAT Sensor on a 1992 Geo Tracker is the Intake Air Temperature Sensor. Replacing the air filter might fix this problem.


The radio wiring schematics for a 1996 Geo Tracker can be found from the service manual. This service manual is available from the manufacturer upon request.


Have your hydraulic clutch fluid checked to make sure it is not low. The clutch master cylinder is located on the drivers side high-rear.


if 16v ? yes. the 96 to 95 direct (long block yes, not manifolds) 95 to 96 , you must swap oil pump and pan. with CKP sensor. see my profile links.




see my profile. yes, 1/2 inch free play.



The 1996 Geo Tracker 1.6 liter engine timing marks can be found on the outside of the main pulley. The timing marks will be scattered around the pulley.


The 1996 GEO Tracker OBD 2 port is on driver side dash next to center console


If the service engine soon light is flashing on the 1997 Geo Tracker, you might have a sensor that has been activated because your vehicle is due to be serviced. You could also have a sensor that is malfunctioning.


On my 1996 Geo Tracker automatic transmission 4wd it's located (in the engine compartment) on the passenger directly behind the intake (to the driver side of the battery) I hope that helps


It is inside he instrument cluster. attached to the speedometer.


One way to do this is to look in your owner's manual. The complete clutch kits average in price close to $200.


The one with the wires running to the headlights :)



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.