Car Computers and Sensors
Car Fuses and Wiring
Chevy Lumina

Where is the computer located on a 1992 Chevy lumina car with a 3400 engine in it?

444546

Top Answer
User Avatar
Wiki User
2009-09-15 19:21:47
2009-09-15 19:21:47
Answer

passanger side behind the kick panel, or near the glove box. inside the car!


Wrong... Not even close...

The computer isn't even inside the car. It is under the hood, behind the coolant bottle. At least you were right on which side of the car it is on (passenger) :)
1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Where is the computer on a 95 Chevy lumina

User Avatar

There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.

User Avatar

The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.

User Avatar

where is my cooling fan relay controll circuit located in a 1997 Chevy lumina, 3.1 engine

User Avatar

It's located near the firewall by the passenger side of the car.

User Avatar

It's a sensor that tells the computer if there is a rod knock in your engine.

User Avatar

On my Chevy lumina it is located right by the gas take on the right side of the car.

User Avatar

The 1994 Chevy Lumina Van fuse box will be located next to the battery box. The fuse box cover should be labeled as such.

User Avatar

No, Chevy Lumina Z34 ever came with a 3.7L engine. So probably not.....

User Avatar

Look where the top radiator hose connects to the engine(water pump).

User Avatar

The Chevy lumina does not have an inertia switch.

User Avatar

At the engine end of the upper rad hose. Make sure when replacing it the spring goes toward the engine.

User Avatar

middle of the engine on the right side. should have code on top of it

User Avatar

The 99 Buick Century 231 engine will fit into a 96 Chevy lumina with a little fabrication.

User Avatar

The engine control computer, ECM, is located on the inside of the firewall directly behind the glove box.

User Avatar

depends on the engine size and the transmission type.

User Avatar

The trunk release for a 1997 Chevy Lumina is located on the driver side floor. An emergency release is also located inside the trunk.

User Avatar

At the engine end of the upper rad hose, When replacing it make shure the spring goes toward the engine.

User Avatar

There is not a camshaft sensor on the '93 3.1 Lumina, just a crank sensor on the back side of the engine between the block and the barrel of the transaxle. Easy enough to get to from underneath the car.

User Avatar

the pcv is located under the fuel injection plenum, towards the back of the engine as opposed to some newer models that have this valve located in the front of the engine on the valve cover

User Avatar

I have a 92 lumina 3.4 Mine was above the brake peddle

User Avatar

If you have the 3.8L engine, ignition timing is controlled by the computer and cannot be altered without making changes to the computer. If you have the 3.1L engine, which has a distributor, you can set the timing as you would on any engine with a distributor.

User Avatar

The 1993 Chevy Lumina 3.1 liter engine timing belt can be found on the front of the engine. You will need to remove the front engine cover in order to access the timing belt.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.