answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2008-12-07 19:35:19

If you are asking where MIL is it is under hood on passenger side Blue/Yellow wire and Black wire. As far as timing notch on crank pulley,paint white, connect timing gun,8 degrees BTDC @800 rpm,if off loosen distributer bolt and adjust accordingly. This is assuming all other components are in working order timing belt etc.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


the timing marks are located next to the top left side of the crank pulley


Where is the timing connector on a 1995 gmc sonoma


10 degrees Before top dead center at idle, with warm engine, and E1 and TE1 shorted on the diagnostic connector.



The 2003 Chevrolet Tracker 2.0 liter 4 cylinder must have a timing CHAIN The Gates website does not list a timing belt for it


In a 2002 Ford Ranger : The 2.3 liter DOHC four cylinder engine has a timing CHAIN


repair timing chain on 2000 chevy tracker


The timing connector is in the pasenger side under the carpet shuld be a brown cable


It requires that two terminals in the diagnostic connector be shorted and the engine run with an inductive timing light. As the engine computer can be damaged by the incorrect shorting of terminals I recommend getting a manual or a printout of a manual that shows the correct way to do this.


ground the diagnostic connector under the dash , set the timing , then unplug connector


Timing connector is located rightside passenger floor where the carpet meets the firewall inside


The 1996 Geo Tracker 1.6 liter engine timing marks can be found on the outside of the main pulley. The timing marks will be scattered around the pulley.


what is the corect timming mark on ceo tracker 2002 v6


Bad points , leaking or fryed coil, shorted wires leading to timing device.


ignition timing or cam timing. see my profile for link. answers both.


You don't, it is controlled by the ECM.


the location of the connector for setting the timing is located behind the glovebox on this truck not on the firewall as with older efi trucks


Hey i run a two bay garage, i have my alldata at work give me a fax number and i will fax you or email the exact procedure. Most of them have a diagnostic connector in the engine compartment the E1 and TE1 are to be shorted with a wire and then the timing set. But to be accurate give me your e mail or fax number and i will send it to you.


The 1.6 liter four cylinder has a timing BELT and the 2.0 liter four cylinder has a timing CHAIN


It isn't adjustable. It is controled by the computer


The 1.6 liter , 4 cylinder , has a timing BELT and the 2.0 liter , 4 cylinder has a timing CHAIN


0 deg -or- TDC With the distributor timing connector disconnected.



When it is disconnected it puts the electronic timing control module in limp mode,and then you can set the timing with a timing light.


electronic spark timing connector



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.