Jeep Grand Cherokee
Jeep Grand Cherokee Laredo
Jeep Grand Cherokee Limited

Where is the cooling fan relay located on a 2000 Jeep Grand Cherokee with a 6 Cylinder engine?

121314

Top Answer
User Avatar
Wiki User
Answered
2008-01-24 01:40:25
2008-01-24 01:40:25

Either take off the bumper or cut a 3" hole underneath the right headlight and you'll be able to access it

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


On the six cylinder it is on the passenger side of the engine. On the eight cylinder it is behind the intake manifold on the back of the engine.


It is part of the fuel pump module, it is located in the tank.


Six cylinder, on the lower passenger side of the engine. Eight cylinder, lower drivers side of the engine.



where is engine block heater on 2000 jeep grand cherokee 6 cylinder engine?


The oil drain plug is located at the bottom of the engine oil pan. The bolt is in the middle where the pan bends.


On a GM engine The #1 cylinder is located drivers side, front of engine.


The engine computer uses the engine coolant temperature sensor to decide when to run the electric radiator fan. It is located very near where the upper radiator hose attaches to the engine.


were is the oil filter located on a 1960 Chevrolet impala 6 cylinder engine located


The Jeep Cherokee 4.0 liter engine cylinder had torque specifications are 120 pounds per square inch. The cylinder head bolts should be torqued at 40 pound intervals.


The 1993 Jeep Grand Cherokee engine control module is located on the firewall in the engine compartment. The engine control module will be on the passenger side of the firewall.


what is the spark plug gap for a 1999 jeep cherokee sport 6 cyl engine???


The 2001 Jeep Cherokee 3.7 liter engine cylinder had bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50 pound intervals.


both the engine and distribitor rotate clockwise


4 cylinder - 5 quarts 6 cylinder - 6 quarts


The air cooling of a 4 stroke petrol engine takes when the air flows on the engine .it takes not by radiation.


for 4.0 liter engine it was located at the upper water outlet pipe above the water pump


The cooling system is the radiator, engine fan, thermostat, and hoses...


Freeze (Expansion) plugs are located in the Engine cooling system. There is no specific location where they must be. They can be installed in the block, cylinder heads, and often in both locations.


4 cylinder 5 quarts 6 cylinder 6 quarts 8 cylinder 5 quarts


From Owners manual for my 1997 Jeep Cherokee 4 liter 6 cylinder engine, it shows 6 us quarts


on the cylinder head of the engine.


In the engine ;-) ---------------------------------------------------------------------------------------------- ANSWER The # 8 cylinder on a Ford Explorer is on the driver's side of the engine nearest the firewall - (Helpfull)


cylinder one is located in the engine compartment passenger side first cylinder close to wind shield.


The 96 SE did come in a 4.0L this swap would be possible.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.