answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2013-08-31 13:21:29
2013-08-31 13:21:29

The computer uses the coolant temp sensor which is located near where the upper radiator hose hooks to the engine.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions



The oil pressure sensor is on the front of the engine, just to the side of the oil filter.


It is on the front of the transmission, between the cooler hoses.


A 1998 Chrysler Town and Country does not have a cabin filter.


A 1998 Chrysler Town and Country would have a 3.8L V6. That engine has a timing chain not a belt.A 1998 Chrysler Town and Country would have a 3.8L V6. That engine has a timing chain not a belt.



It is inside the transmission, on the vale body. It is called a TRS - transmission range sensor.



A 1998 Chrysler Town and Country uses DOT 3 brake fluid.


The spare tire on a 1998 Chrysler Town and Country is mounted under the very rear of the van.


The wiper switch on a 1998 Chrysler Town and Country gets power from and is an input to the body computer.


The fuel level sensor is on the fuel pump module in the tank.


coolant fan temp sensor 1998 crown victoria


It does not have a mass airflow sensor.It does not have a mass airflow sensor.


You will need to purchase a Haynes manual from one of the parts stores. You have to disconnect the coolant temperature sensor. Set the timing to factory specs and reconnect the sensor.


Idle speed is computer controlled and is not adjustable. If the speed is incorrect there is a sensor, actuator, or mechanical failure.


97 Chrysler town & country evaporator bolts location for removal


1998 Chrysler Sebring cooling fan relay switch can be found on the back of the fan. The relay switch is attached to the fan motor with two retaining screws.



The Refrigerant Pressure Sensor / Switch will be located just to the left of the alternator pulley on the firewall....


On the throttle body, opposite of where the cables attach.



Three wire sensor on the throttle body.Three wire sensor on the throttle body.


It is on the top left side of the intake manifold. It is right beside the MAP sensor. 2.5L V6


were is the cooling fan sensor located on a Chevy malabu 2002 3.1L



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.