answersLogoWhite

0


Best Answer

THE CRANK SENSOR IS LOCATED BEHIND THE INTAKE MANIFOLD ON THE RADIATOR SIDE OF THE ENGINE.THE MANIFOLDS MUST COME OFF TO INSTALL SENSOR

Dead wrong, its right above the oil filter on a 2.0 and you dont have to remove anything except a 10mm nut, it pulls straight out, use the wire harness to get a better grip.

User Avatar

Wiki User

โˆ™ 2011-05-30 21:52:56
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the crank sensor in a 96 Plymouth breeze?
Write your answer...
Submit
Related questions

What are the Fuel pressure specifications on a 96 Plymouth breeze?

Fuel. Pressure. 96 Plymouth. Breeze


What makes a 96 Plymouth breeze crank over but wont start?

Check for fuel Check for spark


What type of transmission fluid for 96 Plymouth breeze?

A Plymouth Breeze uses ATF+4.


Where is the IAT sensor on a Plymouth breeze 96?

It is located on the back side of the intake manifold. Kind of hard to get to but reachable.


What is the mpg on a Plymouth breeze?

I have a 96 Plymouth breeze with 2.0 engine. Highway 44 mpg, city 36 mpg.


What is the difference between Plymouth Breeze 96 and 97?

A year


Is the crank sensor location on a 97 breeze different than the 96 becasuse it doesn't seem to be there to replace?

The sensor is located behind the front passenger wheel behind the oil filter


Weres the crank sensor on a 96 2.4 pont engine?

The crank sensor is located at the left front of the engine


Where is the turn signal flasher located on a 1998 Plymouth Breeze?

I have a 96 Plymouth breeze-- to get to the flasher, you have to take the steering column cover off. major pain in the butt.


Does a crank sensor have anything with starting on a 96 Chevy vortec?

if the crank sensor is bad it does not tell the computer that the crank is turning it will not fire up the engine.


Where is the starter for a 96 Plymouth breeze?

Between the front of the engine on the bottom and the radiator


Mirage 96 crank sensor?

The crank sensor on a 96 Mitsubishi Mirage is located on the bottom of the engine, near the oil filter. It constantly monitors the crankshaft and updates the vehicle's computer.


Where is the crank sensor on a 96 jeep Cherokee?

The crank sensor mounts to the top of the transmission bell housing on a 1996 Jeep Cherokee.


Where is the crank sensor located on 96 olds aurora?

by the harmonic balancer


Is the crank position sensor and crankshaft sensor the same in a 96 Jeep Laredo?

yes same thing


Where is crank sensor located on 96 Jeep Grand Cherokee?

The crank sensor is located on the back of the engine passenger side it bolts to the flywheel backing plate


Will not crank no fire codes OK coil OK 96 Dodge Intrepid 3.5 what to mlook for?

try crank position sensor and cam shaft sensor


96 Plymouth Voyager where is MAF sensor?

It does not have a MAF, it uses a MAP (manifold absolute pressure) sensor.


How do you adjust the idle on a 96 Plymouth Breeze 2.0 Liter?

The idle speed is computer controlled and is not adjustable.


Where is the greese fittings on a 96 Plymouth breeze?

The front and rear upper ball joints are the only locations.


Where is power steering pump on 96 Plymouth breeze?

passenger side near firewall down low


Where is crank position sensor located on 96 Cherokee?

In the underside on the far left


Where is the crank shaft sensor located on a 96 Saturn sl?

Next to the starter.


Location of coolant temperature sensor 1997 Plymouth grand voyager 3.3 litre.Is there two sensors?

were is the cooling temperature sensor located on my 96 Plymouth grand voyager


Where is the crank sensor located on a 96 Chrysler Concorde?

Passneger side of the bell housing.