There is a video on U-Tube showing where the sensor is and how to change it. It is above the starter
Next to the starter.
behind the crank pully
The crank position sensor is located on the back side of the engine (the side that faces the firewall) slightly above the starter on the engine block at the number 3 cylinder. It is held on by one 10mm bolt and the wiring plugged into it. I would recommend removing the starter to change this sensor as it will be much easier.
the crank sensor is located just behind the crank shaft pully of the engine.
Where is the crank shaft sensor located in a Audi a6
That year did not have a crank sensor.
where is the crank sensor located on my 1997 Chrysler sebring lxi
the crank sensor is located on the top front of the tranny
There is only one crank sensor fitted, you may also have a cam sensor. the crank sensor is located either around the bellhousing or around the front crank pulley. It either has 2 or 3 wires. It picks the signal off the revolving crank so look for a sensor in the block near flywheel.
Hey Kevin==It depends on your engine but I think it is on the fromt by the balancer. GoodluckJoe the crank sensor is on the back of the block above the starter motor It has a green 2-wire connector to it.
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5
where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine
The V6 in the Saturn VUE is sideways (FWD) vs. the version used in the Cadillac Catera (RWD). On the Saturn, the crank sensor is mounted on the front side of the engine, sort of near where the trans mounts to the engine. Pretty easy to change.
above the starter
where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace
where is the crank sensor located on 2000 nissan sentra
where is the crank sensor located on a 2005 chevy impala
It does not have a crank case sensor.It does not have a crank case sensor.
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
The crank sensor is located on the front side of the crank pulley, between the pulley and radiator.
Lock up, No but a bad crank sensor will prevent the engine from starting.
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
The crank sensor is located in front of the oil pan underneath the car.
The crank positioning sensor is located on the opposite side of the block as the timing belt.