answersLogoWhite

0

  • Dodge Ram
  • Dodge Stratus
  • Crankshaft Sensors

Where is the crank sensor located on a 2001 Dodge Stratus?

User Avatar

Wiki User

βˆ™ 2005-06-30 21:15:57

Best Answer
Copy

I was informed it was on the bell housing somewhere,get the new one and look at the plug in that way you have a reference when your searching.

2005-06-30 21:15:57
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where is the crank sensor located on a 1999 dodge stratus?

Drivers Side Grounded to the block.


Is there a crank sensor in 2006 dodge stratus?

Yes


Do you need a crank sensor on a dodge stratus?

Yes. The crank sensor tells the coil when to fire.


Where is the crank sensor on a 2003 dodge stratus 4 door 2.4 L DOHC?

Where is the crank sensor on a 2003 dodge stratus 4 door 2.4 L DOHC?


Where is the crank sensor located at on a 2004 Dodge Stratus?

It is located right behind the main crankshaft on the passenger side. You might have to take off the crank but might also be able to get your tools in there it depends on how they positioned the sensor.


Location of a 2006 dodge stratus crankshaft sensor?

2006 dodge stratus 2.4 XST, the crank sensor is located under the starter motor, must be removed the starter motor in order to change this, just now I did that job


Where is a crankshaft position sensor located on a 1997 dodge stratus es V6 2.5L?

the crank sensor goes through the top rear of the bell housing.


1998 dodge stratus where is crank sensor located?

On the 4 cylinders it is in the rear of the block. On the 6 cylinder it is in the top of the bell housing.


Where is the crank shaft sensor located on a 2004 Dodge Stratus 2.4L DOHC?

Back of the block, about two inches above oil pan.


Where is crank sensor located on 1997 Dodge Ram van?

the crank sensor is located on the top front of the tranny


Where is the crank sensor located on a 1999 Dodge Stratus 2.4 4-cylinder and is it diffucult to change?

BEHIND THE HERMONIC BALANCER ON BOTTOM OF ENGINE


Where is the crank sensor on a 1993 Dodge Intrepid?

where is the crankshaft sensor located on a 1993 dodge intrepid


95 dodge stratus v6 2.5 ltr where is the crank position sensor located?

on the 1998 the camshaft sensor is in the distributor ,you have to change it....you have to change the whole distributor..the sensor is integrated. the crankshaft sensor is located on the block under the cruise control actuator


Your car does not start at all so what causes no spark in a 1995 Dodge Stratus?

This could be a problem with your cam sensor, or crank sensor.


Where is the crankshaft sensor located on a 1991 dodge caravan 2.5L?

No crank sensor, only the sensor in the distributor.


Where is a crank sensor located for a 1990 Dodge Dakota?

Inside the distributor


You replaced the coil pack on your 1997 2.0l dodge stratus and theres still no fire?

crank position sensor is bad


Where is the crank shaft sensor located in a dodge avenger?

The crankshaft position sensor is located on the top of the transmission. It is located close to the bell housing.


Where is the crank sensor located at on a 1998 Dodge Stratus?

Underneath, bottom side of engine, just above oil pan drain bolt. Its held on by one bolt and has a 3-wire connector.


What causes 2001 Dodge Stratus to shut down and not restart?

it could be the crank shaft sensor or cam sensor i would have the codes pulled to see if these come up.


Where is the crankshaft sensor located on a 1995 Dodge Caravan 3.0L?

the 1995 and before 3.0L's only have the sensor in the distributor. No crank sensor.


Where is the crankshaft sensor on a 1997 Dodge Caravan?

The Crank sensor is located on the transmission housing near the top at the back of the engine.


Where is the crank sensor located on a 1996 Dodge Ram van 3.9 b2500 and how do you install a new one?

The crank sensor is located on the bell housing of the transmission on passenger side. You will need an Allen wrench.


Where is the crank sensor located on a 1995 dodge ram?

The crank sensor is located on the passenger side of the bell housing near the valve cover. It is held in place by two Allen head cap screws.


Is there a crank sensor on a 94 dodge stealth sohc?

it is located in the distributor under the metal cap.