answersLogoWhite

0

  • Chevy Beretta
  • Crankshaft Sensors
  • DIY Projects

Where is the crank sensor on a 1989 Chevy Beretta and how do you fix it?

User Avatar

Wiki User

βˆ™ 2006-02-08 04:08:40

Best Answer
Copy

the crank sensor is located on the back of the engine aprox. 1 inch above the oil pan. there is one bolt holding it in place, after removing the bolt pull the sensor out installation is reverse

2006-02-08 04:08:40
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where is the crank shaft sensor for a 1989 Chevy van 4.3 liter?

Chevy did not use a crank sensor on that year.


Where is crank sensor on 1989 Chevy van 4.3 liter?

It does not have 1.


Does a 1989 Chevy cavalier have a crank position sensor if so where?

its at back of engne just under the manifold


Where is the crank sensor located on 1989 camaro rs?

That year did not have a crank sensor.


Where is the crank sensor on a 1989 Pontiac sunbird 2.0?

Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.


Are the transmissions in a 1989 Chevy Beretta and a 1992 Chevy Beretta interchangable?

depends on engine, mounting, body, ecm, and about a million other things, but possibily


What tools to used to unlock door of 1989 Chevy Beretta?

The key.


Will a 2.8 engine from a 1988 Chevy beretta fit a 1989 Chevy blazer?

Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...


What is Code 43 ESC on a 1989 Chevy Beretta and would that be the reason the car is not running?

thats your knock sensor ESC is Electronic Spark Control which governs timing.


You need to know how to remove the crank shaft positioning sensor for a 1989 2.8 lt. Chevy Celebrity with a V6 Thanks?

The answer depends on what engine you have.


Where can you get a fuse layout diagram for a 1989 Chevy Beretta?

In an owners manual from MOTORLIT.COM


Where is the crank sensor located on your 1989 2.8liter Chevy Corsica?

behind the engine,in front of the transmission, about half way up the side of the block, its very hard to see its near the knock sensor.


Where is the O2 sensor on a 1989 Chevy Celebrity?

The oxygen sensor on a 1989 Chevy Celebrity is located in the rear exhaust manifold on top about the center.


Where is the crank sensor located on a 1989 caprice classic?

depending on what engine you have, 4.3 v-6 or 305 v-8 or if your lucky the 350......chevy never ran a crank sensor on an engine that old. If it wont start, check spark, if you have spark, check fuel.


How do you replace a pin in the door on a 1989?

i need help on how to replace the pin in my 1989 Chevy beretta gt please help me


How do you adjust the timing on a 1989 Chevy 2.2 with coil packs?

If it is a distributorless ignition system, you don't. The timing is all handled by the ecm. It picks up the signal from a crank sensor in the block. It has a reluctor wheel cast in the crank.


Where is the crank shaft sensor on a 1989 2.5 Plymouth sundance?

This car only uses the sensor in the distributor.


Where is cam sensor located on 1989 Chevy truck?

That year did not have a cam sensor.


What is the firing order for a 1989 Chevy Beretta 2.8L V6?

146325 out of haynes repair manual


Where are all the fuses located on 1989 Chevy beretta?

http://forum.topspeedautogroup.com/ thats all i can say...


Does the hydraulic clutch pump brake a lot on the 1989 Chevy Beretta?

Does the Hydraulic clutch pump brakes alot on 1989 chevy berette gtu 2.8liter 6cyclinder 5speed


How do you change the thermostat sensor on a 1989 Chevy cavalier?

where do I find it


How can you get the crank sensor out of the block when it is broke on a 31 grand prix 1989?

pull it apart


Why is your 1989 GMC jimmy turning over but not starting?

the fuel pump or crank sensor


Where can I buy a door hinge pin kit for my 1989 Chevy Beretta GT?

I would try Rock Auto.