where is crank senser located on 2003 pontiac
Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.
it is on the engine
The 1995 Pontiac Grand Am 3.1 liter engine crank shaft sensor is located inside of the rear engine cover. You will need to remove the rear engine cover in order to access the crankshaft sensor.
The crank shaft position sensor is located behind the harmonic balancer/crank shaft pully on the front of the engine. You can see the wires for the sensor run behinf the pully into a plastic housing.
Where is the crank shaft located on a 1999 Pontiac Bonneville? I have bought the part. Just can't find where it goes.
most likely behind the plate covering the timing gears, at the front of the engine.
Does your vehicle have the LT1? if so there is no crank sensor.. there is an optic sensor in the distributor that controls all..
The crank sensor is located behind the hamonic balancer
The crank sensor is located on the back of the engine passenger side it bolts to the flywheel backing plate
The crank sensor should be located down next to the crank shaft, Right side of car They are hard to see, and i think you have to remove the crank pully to get the sensor out, this is a comon problem on the 3.8 L Gm. eng Not a very expensive part, Usualy the car won't start when faulty
on the back of the motor wright below the crank sensor
The crankshaft sensor is on the side of the engine behind the alternator. It is mounted close to the oil filter,
it is likely the crank sensor... located under the harmonic balancer.
For the 2.2L engine, remove the starter. The sensor is screwed into the engine block behind the starter with a 10mm bolt. The wiring plugs into the front of the sensor facing the radiator.
IT SHOULD BE LOCATED UNDER THE MANIFOLD BOLTED TO THE BLOCK
Check the 2001 Grand Ams crank shaft position sensor first. If the sensor is bad then the engine will not get fire or start.
Usually a crankshaft sensor is located on the bellhousing of the transmission
The crank sensor is located on the top of the bell housing on the drivers side.
in a toilet
on the 2.4 its to the left of the starter above the oil filter
on 2.3l It is on the front of the motor under the intake manifold next to the starter.
I have a 1992 Pontiac Sunbird with 2.0 four cylinder in it, just found the crank sensor on it, to replace it. It is located on the FRONT side of the engine, below exhaust manifold and just above the A/C compressor. HOPE THIS HELPS SOMEONE ELSE!
Where is the crank shaft sensor located on a 2002 grand am 2.2 l ecotech engine