The crankshaft sensor is in the front of the engine.Above the starter.You will have to drop the starter.2 15mm bolts.Look up and there it will be.
what can make a crank shaft sensor keep goin bad even if its been replaced 4 times.. in a 2000 oldsmobile bravada
they are 5.25 inch round just replaced mine in a 99 intrigue.
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
this happened to my 98 intrigue, i replaced the spark plugs and hasn't happened yet...worse case scenario you might have to replace the spark plug wires as well but I've only replaced the plugs and its fine.
A damaged crankshaft will need replaced.A damaged crankshaft will need replaced.
I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.
The front wheel bearings and hub come as one piece. The bearings alone are not serviceable.
Air bubbles remaining in the system
it is located next to the oil filter right above the oil pan
A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.
Our check engine light was on in our 1998 Intrigue. We went to Autozone and they pulled the codes and saw that it was either one (or both because they said there was 2). If your light is not on I am not sure how to find out otherwise. Autozone said that it tripped our light.
the seal on the crank shaft needs replaced