The 1995 Mitsubishi Eclipse crankshaft position sensor is located on the back of the engine. The crankshaft position sensor will be near the bottom of the engine cover.
Found it at front bottom of engine
Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.
In my '97 Eclipse GST (the convertible model of your car), the Crankshaft Position Sensor, or Crankshaft Angle Sensor, is located behind the crankshaft pulley. To get to it, the Mitsubishi shop manual lists the removal of the timing belt. Not a fun job. Since the timing belt will be removed anyways, this is a good time to install a new belt. The Mitsubishi dealership also suggested replacing the timing belt tensioner when re-installing the timing belt.
Inside the distributor.
The crankshaft position sensor is located on the front of the engine inside the timing belt cover
where is the camshaft position sensor located on a 2001 mitsubishi eclipse v6
It's located next to the crankshaft pulley (the timing belt is going around it). You will not miss it. There is only one sensor there.
it is located on the drivers side at the the crank behind the covers
right behind the harmonic balancer.... has 2 bolts into the motor and 3 wires that go into the motor and out of the side with the connector
It's behind the timing belt. Even so you do not need to remove the belt, you will have to remove the pulley and covers. If you want to replace it.
Where is the radio antenna located on a 2003 Mitsubishi eclipse