answersLogoWhite
Ford Taurus
Dodge Intrepid
VW Jetta
Crankshaft Sensors

Where is the crankshaft position sensor on a 1994 intredid w a 3.3L?

91011

Top Answer
User Avatar
Wiki User
Answered 2006-07-22 13:37:33

UNDER HOOD, DRIVER SIDE, UPPER ENGINE AREA, MOUNTED ON END OF ENGINE BLOCK.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


I am not sure of what year you are talking about. But the 1993 and 1994 Altima does not have a crankshaft sensor(crankshaft position sensor) .....


There is a crankshaft position sensor , at the front of the engine


Crankshaft sensors were not used in 1994 models.



The 1994 Volvo 850 crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.


where is the crank sensor for 1994 toyota corolla 1.6 ltr


AnswerActually it doesn't use one. The sensor inside the distributor is the crankshaft position sensor.



It is bolted to the bell housing on the passenger side.


No, just the pick up plate in the distributor.


inside the distributor along with the crankshaft position and cylinder position sensors


On my 1994, the CRANKSHAFT POSITION Sensor (or sometimes referred to as Engine speed sensor) is located behind the Oil Filter & Front motor mount near the starter. It's really hard to see, and even harder to get to.....


1994 corvette quit accepting more and more throttle then died and wont crank


I cant remember if a 1994 had a distributer or not. If it has a distributer, there is no crankshaft position sensor. That information is a calculated value using the input from the distributer stator(pickup coil). If there is no distributer, then there will be a crank sensor on the front of the engine down by the crank pulley.


it is located on the drivers side at the the crank behind the covers



CID = cylinder identification sensor is the same as a Crankshaft Position Sensor. Look for it by the harmonic balancer


where is the crankshaft sensor on a 1994 dodge pickup with a 5.9l engine?


The crankshaft position sensor is mounted on the front of the engine, just to the left of the crankshaft pulley ( when you are looking from the front of the Explorer. Helpfull


where is the cranksensor on 1994 chevy pickup with a 6.5 engine


under the car with extention and universal, with a 11 mm.


According to my manual that goes up to 1996, yes the 3.0 does have a crankshaft position sensor.


The 1994 Ford F1 50 crankshaft sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.


Not inside, the crankshaft position sensor goes through the top passenger side though.


Pretty sure it's at the front end of the crank.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.