The crankshaft position sensor is on the top driver side of the transmission bell housing.
The crankshaft position sensor is bolted to the bell housing of a 96 Grand Cherokee. It is at the top of the bell housing, just on the drivers side on a 4.0 L and on the passenger side on a V8.
The crankshaft position sensor is on the top driver side of the transmission bell housing.
Crankshaft position sensor mounting bolt.
The crankshaft position sensor is on the top of the transmission bell housing behind the passenger side cylinder head.
The crankshaft sensor on a 4.0L Jeep Grand Cherokee is mounted on the top driver side of the transmission bell housing.
The sensor can be checked by the use of an ohm meter on the sensor terminals. Unfortunately I do not have the specific data for this vehicle.
check the crankshaft sensor
The crank sensor should be on the drivers side of the transmission bell housing. It's more towards the top of the bell housing. The easiest way to get to it is reaching down from the top of the engine just below the valve cover. Atleast that is where it is on my 91 4.0L
Usually a crankshaft sensor is located on the bellhousing of the transmission
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
It is on the right rear of the engine block(pass side) just above the oil pan.
yeah it has one and hope you don't have to replace it