Chevy Cavalier
Crankshaft Sensors

Where is the crankshaft position sensor on a Chevy Cavalier 2.2 l SFI?

202122

Top Answer
User Avatar
Wiki User
2014-07-04 13:49:43
2014-07-04 13:49:43
AnswerThe crankshaft position sensor should be located on a small metal bracket very close to the harmonic balancer which is attached to the end of the crankshaft. If you are having trouble locating the harmonic balancer, it is the lowest pulley on the passenger side of the engine, in the centerline of the engine.
1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?

User Avatar

on a 93 Chevy cavalier ls how to get the crankshaft sensor out of the block also can I remove the oil pan to get to the crankshaft sensor

User Avatar

The crankshaft position sensor is located behind the starter on the front of the engine. Hope this helps! Mitch art_y2k1@yahoo.com

User Avatar

The 2004 Chevy Malibu crankshaft position sensor location is dependent upon the type of engine. In most cases the crankshaft position sensor is on the back of the engine.

User Avatar

No, the 1983 model does not have a crankshaft position sensor. Only distributorless engine needs a crankshaft position sensor.

User Avatar

The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.

User Avatar

Its on the firewall side of engine between transmission and engine just below the ignition coil packs one of the wire connectors from ignition module go to crankshaft position sensor

User Avatar

Locate crank shaft sensor 2005 Chevy aveo

User Avatar

The crankshaft sensor is located on the side of the motor towards the firewall. It is located more towards the oil filter,

User Avatar

Hey Jeff== It depends on which engine you have but I imagine it is on the module and senses notches on the crankshaft. GoodluckJoe

User Avatar

Next to the oil filter, bolted to the block.

User Avatar

its located at the rear of the engine (center) attached to the block

User Avatar

The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.

User Avatar

The crankshaft position sensor is located right above the starter, you may have to remove the starter for better visibility.

User Avatar

how do you change a crankshaft position sensor on a 1999 chevy camaro z28?

User Avatar

Onh the front of the engine to the left of oil filter by the starter. This will affect your car and how it runs because this sensor and camshaft sensors are supposed to be synchronized

User Avatar

Where is the crankshaft sensor located on a Chevy 1500 sil. turbo diesel truck?

User Avatar

Most likely on front cover of engine by crankshaft

User Avatar

You will find the crankshaft position sensor on the passengers side of the engine block, close to the starter.

User Avatar

Back side of the engine near where the transmission mounts to the engine. You have to jack up the car and crawl under it to see it. There are two sensors there.....the crankshaft sensor and the knock sensor.

User Avatar

way is my crank sensor over heating on my 2005 colbalt


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.