Car Computers and Sensors
Honda Civic
Crankshaft Sensors
Honda Civic EX

Where is the crankshaft position sensor on your Honda civic 1991 located?

626364

Top Answer
User Avatar
Wiki User
Answered
2011-10-03 04:08:31
2011-10-03 04:08:31

inside the distributor

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


inside the distributor along with the crankshaft position and cylinder position sensors


The crankshaft position sensor can be found on the bottom of the engine in a 2000 Honda Civic EX. It is next to the crankshaft itself.


Depending on the year it could be in the distributor or by the crank's pulley. On 93-98 Honda passports with the 3.2l engine the crankshaft position sensor in located on the passenger side of the engine near the engine mount. 93-95s did not have the camshaft sensor though. that was added in 96 and is located on the d/s valve cover in the outside upper corner


This would be located right behind the crankshaft. For the best assistance, you can use the users manual to get it fixed.


The cylinder position sensor is located in the distributor.



p1337 crankshaft position sensor 2 no signal



To make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads will take a lot of work. You will have to redo everything under the hood.


Crankshaft Position Sensor A Circuit Range/Performance


A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.


Inside the distributor. Replace distributor with OEM Genuine Honda Parts only.


The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.


The Throttle Position Sensor is located on the throttle body



The camshaft position sensor, also referred to as the TDC sensor, is located under the same cover as the timing belt. It is a good idea to check the condition of the timing belt and water pump if you are changing the camshaft position sensor.


Crankshaft sensor on Honda/Isuzu 3.2l V6 is located on the lower passenger side engine block . If you look through the wheel well at the block just behind the motor mount you will see the wiring harness plug going in.


The CKP looks like a small gear with long teeth located inside the distributor housing. If the CKP fails, unfortunately you must replace the entire distributor housing.


Where is the LAF sensor located on a 92 honda civic?



The 2006 Honda Accord camshaft position sensor can be found on the back of the right-hand cylinder head. The camshaft position sensor should be labeled as such.


its behind the crank pulley on that gear at the end of the crankshaft on the timing belt side of the motor



The crankshaft sensor is located at the bottom of the engine timing chain cover. Use the owner's manual in case you need help.


Oxygen sensor is located at the exhuast Manifold.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.