Want this question answered?
You have to remove the starter motor to view the sensor position Depends on which engine is fitted 4 cylinder 1.8 petrol is at the front of the engine at the flywheel end.
The crankshaft sensor on a Rover 200 is located below and to the right of the generator and cylinder head temperature sensor. It is on the driver's side of the engine and above the oil filter.
Lower left side of crankshaft-looking at engine from front.
the crankshaft sensor lokited ner the flaywil bihind the transmisin
The crankshaft sensor is located at the back of the engine (4.0), and just above the bellhousing for the transmission. It is on the drivers side, and i believe it has a yellow cover on it. i may not be remembering it correctly, but it seems like its yellow.
Begin by removing the rear engine cover from your 1997 Land Rover Discovery. Remove the crankshaft sensor wiring harness. Remove the crankshaft sensor retaining bolts. Reverse the process to install your new crankshaft sensor.
It is located in a radiator hose, on a Petrol this is on the left side of the fan when looking at the engine.
The fuel pump is an in tank unit and is located inside the petrol tank.
where is the speed sensor on a rover 200
Crankshaft is inside the lower part of the motor.
If the vehicle is a petrol V8 it is located at the front of the intake manifold where the top hose enters the block.
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.