Chevy Celebrity
Dodge Dakota
Oldsmobile Cutlass Supreme
Crankshaft Sensors

Where is the crankshaft sensor located on 87 Chevy Celebrity 2.8l?

123

Top Answer
User Avatar
Wiki User
Answered
2010-03-03 04:06:41
2010-03-03 04:06:41

On a 1987 to 1990 Celebrity with 2.8/3.1L engine the crankshaft position sensor is on the side of the block beneath the exhaust manifold on the firewall side of the engine.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


No, the 1983 model does not have a crankshaft position sensor. Only distributorless engine needs a crankshaft position sensor.

Where is located the crankshaft sensor in Chevy avalanche 2002 engine 5.3?

crankshaft sensor is located just behind the crankshaft pulley on the front of the engine(passenger side of vehicle).

The oxygen sensor on a 1989 Chevy Celebrity is located in the rear exhaust manifold on top about the center.

The crankshaft sensor is located in the engine on a Chevy 1500 truck. This is under the hood.

The crankshaft sensor is located on the side of the motor towards the firewall. It is located more towards the oil filter,

The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.

That year model did not use are have a crank sensor.

Where is the crankshaft sensor located on a Chevy 1500 sil. turbo diesel truck?

That year did not have a crank sensor on it.

most Chevy cps's are located in the timing cover(behind the balancer). I'm not certain on the Celebrity, but it would be a good place to check.AnswerOn my 1986 Celebrity 2.5, it is beneath the intake manifold on the back of the engine.

You can replace the ignition control module and the crankshaft position sensor as required.

Most likely on front cover of engine by crankshaft

The crankshaft sensor on a 2001 Chevy Silverado 8100 is located on the bottom of the engine, near the starter. It constantly monitors where the crankshaft is in its rotation.

how to tell if my crankshaft sensor is not working

It's located under the car just behind the starter. Both sensors are there. The Throtle sensor and the Crankshaft sensor. You have to take out the starter to get to it.

where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks

The knock sensor on a Chevy Celebrity 2.8 L engine from 1987 thru 1990 is located on the back side of the engine(next to the firewall) below the exhaust manifold. There are actually two sensors there, one is the knock sensor, the other is the crankshaft position sensor. The knock sensor is threaded into the block with a pipe thread, the crankshaft position sensor is held in with a 10 mm screw and is near the center of the block. They are both accessible with the engine in the car, but they are a bit of a pain to get to.l

The crankshaft sensor is located on the side of the block below the exhaust manifold on the firewall side of the engine. It is held in by a single bolt. Access is quite tight but it can be replaced with the engine in the car.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.