Oldsmobile Cutlass
Oldsmobile Calais

Where is the crankshaft sensor located on a 1990 Oldsmobile cutlass ciera 2.5 l?

123

Top Answer
User Avatar
Wiki User
Answered
2010-04-03 04:36:17
2010-04-03 04:36:17

if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


where is the crankshaft sensor located on a 1988 cutlass supreme


The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.


where is the knock sensor located on 93 cutlass ciera


The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.


where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine


The 1984 Cutlass is a model of car produced by the company Oldsmobile. The oxygen sensor is typically located near or on the engine block.


It should Be located on the top of the transmission.


Nee more info cutlass supreme or cutlass ceira which engine 3.1-- 3.8-- 3.3-- ????? Oldsmobile cutlass ceira 3.3 liteer engine


It takes a special gauge to install the crank sensor. It can be rented from some parts stores.


The Crankshaft sensor is located behind the Harmonic Balancer on the front-passenger side


The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.



what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6


The crankshaft sensor is in the front of the engine.Above the starter.You will have to drop the starter.2 15mm bolts.Look up and there it will be.


it is located under the coils and ignition modual it is mounted under it all, it comes out with the modual, and be careful if it has been there a while you may break it,


Usually in your rectum. Depends on how deep you like it?


Behind the harmonic balancer (dampner) that is located behind the crankshaft pulley.


i have a 90 cutlass ciera with a v6 3300 and just replased that. it is called a combanation sensor. its the crankshaft and cam together located at the back of the harmonic balancer attached to the block. it has 2 bolts on the right side holding it to the block a one in the middle to hold the sensor in place and the sensor sits in it and faces the harmonic balancer on the back of the interrupter rings


The "mass air flow" sensor would be located in the snorkel between the air filter box and the throttle body.


check main pulley area bottom by harmonic balance


On front cover of engine by crankshaft pulley.



if it has a 3.1 or 3.4 it is located between the engine and the trans just above the oil pan.


Where is a crankshaft sensor located on a nissan almera 2001


depending on the year, I have a 2002 intrigue, it is located just above the starter, it needs to be removed to remove the crankshaft sensor, 15mm for starter and 10mm for sensor 1 bolt , not to difficult.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.