answersLogoWhite

0

Car Computers and Sensors
Dodge Durango
Crankshaft Sensors
Skoda Octavia

Where is the crankshaft sensor on a 96 Dodge Durango?


Top Answer
User Avatar
Wiki User
Answered 2006-10-02 23:35:04

Dodge did not produce the Durango until 1998. It is located on the bell housing on the right side of the engine where the transmission mounts to the engine

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Where is the crankshaft position sensor on a 96 dodge stratus with a 2.5lv-6?

The crankshaft position sensor is located on the rear of the engine, on the driver's side just below the distributor.


Where is the crankshaft position sensor on a 96 Ford Probe SE?

"Where is the crankshaft position sensor on a 96 ford probe SE?"


Where is the crankshaft sensor on a 96 dodge dakota 3.9l?

on the passanger side. it i located on the trans housing where the engine and trans meet.


Where is the crankshaft position sensor on a 1993 Corvette?

Corvette didnt have a Crankshaft Position Sensor until 96.


What is the timing for a 96 dodge 5.2 v8?

The distributor is synched (zeroed) to the crankshaft sensor with a scan tool.. It can not be done with a timing light.


Will your 96 v-8 transmission for a Dodge Durango fit in a 3.9 6-cylinder Dodge Durango it is a 97?

No, the V6 and V8 transmissions are different.


Is the crank position sensor and crankshaft sensor the same in a 96 Jeep Laredo?

yes same thing


Where is 95 blazer 4.3 crankshaft sensor?

It does not have one. They did not put them on until 96


96 Jeep Grand Cherokee Cranks over but will not start?

check the crankshaft sensor


Where is the temperature sensor located on a 96 dodge neon?

http://www.techknowman.com/Dodge%20Neon/Dodge%20Neon.htm


Where is the crankshaft position sensor located on 96 sebring convertible?

See the related link for a picture.


Mirage 96 crank sensor?

The crank sensor on a 96 Mitsubishi Mirage is located on the bottom of the engine, near the oil filter. It constantly monitors the crankshaft and updates the vehicle's computer.


What causes a crankshaft position sensor to go bad on 96 eclipse?

If you have a 4g63 motor a common problem is crankwalk, this will damage or break off the sensor.


Where is the crankshaft position sensor on a 96 Ford Bronco 5.8L?

near the harmonic balancer, its under the timing pointer.


Where is the crankshaft position sensor on a 1996 jeep grand cherokee?

The crankshaft position sensor is bolted to the bell housing of a 96 Grand Cherokee. It is at the top of the bell housing, just on the drivers side on a 4.0 L and on the passenger side on a V8.


Where is the MAF sensor on a 96 Dodge Neon?

The Dodge Neon does not have a MAF (Mass Air Flow) Sensor. It does, however, have a MAP (Mass Air Pressure) sensor located on the intake manifold between the two left runners.


Where is the temperature sensor on a 96 dodge caravan?

Next to where the upper radiator hose comes out of the engine.


Where is the coolant temp sensor located on a 96 dodge ram 3.9 liter?

It is under the alternator.


How can you change your Crankshaft position sensor on a 96 Acura Integra?

change your distributor. its just a part inside there next to the ignition coil


Where is the cps on a Jeep Cherokee 96?

The Crankshaft Position Sensor is attached to the bellhousing.The CPS detects teeth on the flyweel as thay pass the sensor during engine operation and thus provides the computer with info concerning engine speed and crankshaft angle. Hope this helps.


Where is coolant temp sensor located on 1996 dodge ram truck?

the sensor on 96 V10 motor is in front on top behind air con


Where is neutral safety switch for 96 Dodge Intrepid?

Inside the transmission, on top of the valve body. Dodge calls it a trs ( trans range sensor)


Your 96 camaro z28 won't start because of lack of spark?

96' z28 won't start because lack of spark. Could it be crankshaft position sensor? I just replaced distributor.


How do you fix a '96 Plymouth Voyager that stops sporadically while traveling cleaned battery terminals but car now will not start?

i had the same fault with my 1996 dodge Plymouth, 3.3 litre engine. i replaced the crankshaft sensor and viola problem was resolved.


Where do you locate the crank shaft censor on Renault clio 96 m reg 1.4 auto because its faulty?

The crankshaft position sensor can be found on the back of your 1.4-liter engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.