answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2012-10-22 14:54:31
2012-10-22 14:54:31

On the front of the engine, the thing with the spark plug wires attached to it.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.



5W-30 is the preferred oil ( according to the 1996 Mercury Villager Owner Guide )


The coil UNFORTUNATELY is built in the distributor.



Number @ cylinder is located at the front of the engine nearest the distributor and closest to the grille. FYI, the distributor rotates counter clockwise. ------------------------------------------------------------------------------------------------------- Just adding to the answer : firewall 1-----3-----5 2-----4-----6 front of Mercury Villager V6 > driver


How do you remove the driver s seat from a1997 mercury villager



There is no "chip" that can be replaced in the distributor, it is serviced as a unit. There is no chip in the distributor cap.



the sensor on the 3.3l mucury villager is integrated into the distributor


Go look at the answer that was posted for, "How do I put freon in a 1996 mercury villager?" This answer is most likely what you are looking for.


No, the PCM does based on the computer map and various inputs, including cam and crank position. A distributor pick up (cam sensor) will have an affect on injector timing.


If your car has an external coil, it will be bolted to the engine near the distributor. Otherwise, it is inside the distributor housing.


According to one of Fords websites : For the 3.0 liter V6 engine in a 1996 Mercury Villager : The spark plugs are gapped at ( .034 inch )


Trouble code P1320 means: Distributor Signal Interrupt


Cam position is taken from the distributor, there is no external cam sensor.


Take the distributor cap off and turn the engine. If the rotor turns it's not "stuck".


Timing is set by the PCM and is not adjustable. The distributor should always be reinstalled in the same position it was removed from.


The ignition coil is part of the distributor assembly and is inside the distributor. It is not available as a separate part.


According to the website about.com : For a 1996 Mercury Villager , 3.0 liter SOHC , V6 engine : The firing order is ( 1 - 2 - 3 - 4 - 5 - 6 ) The engine cylinder locations are numbered : firewall 1------3------5 2------4------6 front of vehicle The distributor rotor turns COUNTERCLOCKWISE


To the right of the steering column under the dash.


That is incorporated with the latch assembly.





Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.