ok. The coolant temp sensor on the 3.1 is located adjacent to the ERG- What does this mean? As you are looking at the engine- on YOUR right hand side of the intake plenum, under the intake housing is the little sensor. you have to look for it if you don't know what it looks like. It is a two wire connector and it is on the right (your right) top side of the engine.
AnswerFollow the Large Radiator Return Hose on the driver side to the Water Outlet Pipe/Stat Housing beneath the Throttle Body. The Sensor is ported into the Water Outlet Pipe/Stat Housing.where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
Its located on the bottom of the coolant reservore.
It should Be located on the top of the transmission.
The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.
Coolant Temperature Sensor/Switch (For Computer) ECCS Component Parts Location
Should be at the lower section of the coolant recovery tank
check/replace the engine coolant level sensor located in the engine coolant overflow reservior (located at the rear of the engine compartment pass. side)
It should be located in the recovery tank.
next to the thermostat housing.
the sensor on 96 V10 motor is in front on top behind air con
Answerits the coolant level sensor, located on the passenger side of the radiator.the sensors are known to go bad over time.the engine coolant temp sensor is located on the drivers side head, and will have 2 wires on 99+ and 3 wires on a 1998 ls1 f-carActually, coolant temperature module / sensor is located on the water pump of your '96 Z28. Changed my last year - fairly easy to do.
wher is the pcv located on a 1996 olds cutlass supreme 3.4 l engine