0
It is behind the throttle body, on the intake manifold.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is code 43 1992 Chevy S10 blazer?
knock sensor
What standard trans fits a 98 S10 Blazer 4x4 with a 43?
any from 88 to 98
Where does the small wire on the solenoid originate from on a 1992 S10 Blazer 43?
probably the ignition switch if you are refering to the starter solenoid.
Where can you find a schematic for the ignition control module of a 43 vortec engine in a 1994 Chevy Blazer S10?
Owners manual, positive.
Where is the EGR valve located on a 1999 Mercury Cougar?
The EGR valve is a round disk like device about 43-4 inches across with a hose coming off of it on top of the engine near back right of center of engine.
Gm scanner found code 43 on 86 s10 blazer referring to electronic spark timing ESC circuit - low voltage detected or electronic spark control circuit problems what and where is this and how to fix?
I have a 92 s10 blazer and my code 43 was fixed by replacing the knock sensor. so maybe check the knock sensor and the wiring from that to the ECM.
1986 Chevy Astro Van V6 43 hesitating on take off but then runs fine after that?
I think it's your EGR Valve. The EGR valve, or Exhaust Gas Recirculation valve, is a vacuum controlled valve which allows a specific amount of your exhaust back into the intake manifold.The EGR valve, or Exhaust Gas Recirculation valve, is a vacuum controlled valve which allows a specific amount of your exhaust back into the intake manifold. You'll know if your EGR valve is stuck or malfunctioning because your car will experience symptoms like rough idle and bucking on acceleration.
What is the cause and corrective action required for pieces of carbon getting caught in the EGR valve on a Chevy S-10 with a 43 Engine?
an EGR valve gasket is available that has a screen to block the carbon. They cost $5.69 at the autoparts store in my city.
What is a code 43 on a 1993 s-10 blazer?
knock sensor
1989 cheevy blazer 43 Ecm code 12?
System Normal
Why would a 1988 Chevy Blazer S10 with a 43 engine 6 cylinder shake?
it might be a broken motor mount. there are two mounts located towards the bottom of the left and right side of the engine make sure you are getting spark to all cylinders. (check for Misfiring)
Why won't your engine stay on For a 1991 Chevy Blazer S10 43 liter engine?
My 94 blazer had this problem and it was the fuel pump. My Blazer eould start and run for a few seconds and the die,after Ichanged the fuel pump it started reigt up. . Awhile back my truck wasnt staying started for more then five seconds, and it turned out that it needed the RPMs adjusted bc it wasnt high enough to keep the truck going =( didnt cost much though
