Rear of the engine block, near the oil pan.
Coolant sending unit is located at the front of the left cylinder head
The coolant temp sensor on a 2002 Silverado with the 6.0 engine is located on the drivers side cylinder head close to the front of the cylinder head.
The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.
where is the temperture sensor located on a 2002 chevy trailblazer with a 4200 motor
The 1989 Chevrolet 350 cubic inch engine coolant sensor is located on the front of the engine. The coolant sensor will be near the thermostat housing.
1st cylinder up front on the drivers side.
In the cylinder heads.
The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.
Not sure but, if it does have a bleeder it would be located at the highest point where the coolant flows in the engine.
The coolant temp sensor screws into the thermostat housing. This is located where the top radiator hose connects to the engine.
drivers side of engine block
The coolant temp sensor will be located very close to the thermostst housing.
I have a Chevy 2004 Colorado V3500 5 cylinder engine. Filter is on the passenger side at the front of the engine. Easy to get too.
Bottom right of the water pump. Dead center of the engine in the front.
located coolant temp sensor
Facing the engine, it's on the top left. It can be seen without moving anything.
The coolant fan relay on a 1988 Chevy Celebrity with 2.8L V6 is on the radiator support bracket behind the right hand headlights.
The engine block coolant drain plug on a 350 Chevy Tahoe is above the oil pan, mid engine on driver's side
Place something to catch the engine coolant beneath your 1990 Chevy Corsica radiator. Remove the radiator drain plug with a 9/16 ratchet. The engine coolant will drain out.
You either have a cylinder head cracked are gasket leaking coolent into a cylinder. pRESSUR TEST THE COOLANT SYSTEM WITH SPARK PLUGS REMOVED AND SEE IF ENGINE COOLANT BLOWS OUT A SPARK PLUG HOLE WHEN CRANKING ENGINE OVER. If it does then remove the heads and have them checked. engine coolant makes white smoke when being burnt.
There's a coolant temperature sensor located on the lower part of the water pump on the drivers side.
The coolant level sensor on a 2.4 L is under front of the coolant reservoir towards the engine. It has a 2-wire connector on it.
It is in the drivers side head between the first 2 spark plugs.
on top left facing engine,it is a small valve on top of pump!! on v6.
Assuming this is a 4.3L engine the ect (engine coolant temp sensor) would be located next to the thermostat housing.